If you place a folded shop towel under the valve faces it will keep them in a better position
@keithh74834 жыл бұрын
Good stuff. Your valve job went way smoother than mine (I was using harbor freight junk spring compressor). I had to fight and fight to get the spring retainers out! Anyway since you have it apart, put a little lapping compound on the valves and lap them to the head for better seal. I just chucked mine in a cordless drill.
@chrisbryant16573 жыл бұрын
Thanks for sharing! I received the btr valve spring compressor tool today and I had the same question on which way to orient the aluminum plate that you place on first. 👍
@ya.boii_angel2828 Жыл бұрын
Fack men I never leave comments but this was hella helpful 🤘🏾
@shawng7902 Жыл бұрын
I've wondered since the 1st time I saw one of these, what that eyelet is for lol. I wish I had bought one of those compressors just to be quick. I broke Orielys on 1st 660 spring lol. So I made a great one for the bench out of a 12" clamp and welded the 13/16" spark plug socket you never use onto it. cut a window in the socket and it will clamp 400# spring with just finger pressure.
@brianbreitenbecker58762 жыл бұрын
The only thing I highly recommend is valve seal fitting sleeves. $6 bucks to be 100% sure the machined sharp edge of the valve does not scuff/cut new seals.
@hybridazndetailing164 жыл бұрын
Haha I was going to say I think you forgot something, but then you caught yourself 😂😂
@erick10763 жыл бұрын
The cutouts on the tool is for if your using larger springs like the beehive springs
@bobbybenn8275 Жыл бұрын
Where did u find this tool?
@jnarvaez894 жыл бұрын
Is the small gap between the seal and retainer normal on a dual spring setup?