Thanks for watching 😊 10 watchmakers have 10 process. I want to introduce one story for young watchmakers. I don’t need too much views 💪💪

Thank you very much ☺️ I want to say, watching is not special. Then take a very easy way.

Thank you very much ☺️

Thank you very much 😆

Thanks for watching ☺️

Thanks for watching. ☺️

Thanks for watching ☺️

Thanks , me too ☺️

Thanks for watching. I usually not use oil. But put a little oil is better I think too. 😆

Thanks for watching 😊 I’ll make more smooth burnisher you said. I have couple of them , Other one is more rough. This one is my favorite 😍

Thanks for watching ☺️ I think it can do 1mm or less. But when do thick pivot , can polish 2mm or more.

Thanks for watching. I usually use vise for a drilling machine about 15cm x 15 cm. It’s not expensive. Watchmaker’s vise is usually set side of bench, I scared dropped a parts. In this vise, work on inside of bench.

@@tanakayawatch thank you will look in to this! I don't have a lot of room to put a vise so this would be the perfect solution. Is it stable? It looked decent in the video.

It’s no problem for Jacot tool. If it moved you should put some RODICO ☺️

Of course,it can do nearly same with lathe. But it can push harder that steel will more hardness and can set a center easily. Other way, Jacot tool can do same to lathe.

Thanks for watching 😊 I use the SHAMISEN's line , it's a Japanese guitar. 🎸

ホゾの研磨用の道具です。作った天真や歯車のホゾを磨くと同時に加工硬化させてよりスムーズに動く様にします。 これは違いますが、同じ構造で旋盤として使う事の出来る物もあります。チャックでワークを噛むより中心が出ますので、より中心に拘る人には良いかも知れません。 私は大抵旋盤で済ませてしまいます。

@@tanakayawatch 加工硬化ができるんですね。　でも、田中さんが言っておられるように旋盤でも可能ですよね。 当時の人の工夫というか　技術が感じられます。 凄い世界ですね。

昔の人は色々考えてますね。 旋盤で切れないバイトで切れないなと思っている時は、ワークの表面を滑らせてしまっていて、勝手に加工硬化させて、さらに切れなくする悪循環になります。

Thanks for watching ☺️ It’s a polishing tool for a pivot. Balance staff and wheels.

Thanks for watching ☺️ Tool name is JACOT-TOOL. Bought from second hand shop. You should get it e/bay easily.

Thanks for watching ☺️ I’ll check it. Very thanks. I want to learn more.