HPI SAVAGE FLUX XL SAVOX SERVO UPGRADE

  Рет қаралды 24,075

Fun Gaming And R.C.

Fun Gaming And R.C.

11 жыл бұрын

Just a quick video of my new upgrade to my HPI Savage flux XL. I needed something strong to turn those Big Joes. lol I think Savox is the best thing out there. You just need to buy a voltage protector by spektrum. Part # is SPM1600. If your servo starts glitching. Any questions, Feel free to ask,

Пікірлер: 54
@higgout
@higgout 11 жыл бұрын
Sweet upgrade.
@Leprechaun79
@Leprechaun79 11 жыл бұрын
Savox servos are amazing. I personally like them better than Hitec. Well, maybe not as much as my 7955-TG in my Mugen. However, I only buy Savox servos now. Great vid, brother!
@victorm316
@victorm316 11 жыл бұрын
Thats a good idea. once the snow clears up. I will do that
@victorm316
@victorm316 11 жыл бұрын
Well the thing i bought is $3 plus shipping, Thats pennies to me. No big deal. They are power hungry, I agree with you
@xKELxPAYNE
@xKELxPAYNE 11 жыл бұрын
Good upgrade. The big joe take alot of power to turn them. Thumbs up. Try using a 6 cell pack. It make a big difference.
@mikeravain8757
@mikeravain8757 11 жыл бұрын
Lol forgot to finish my thought...the various glitch buster caps do a great job as an alternative to receiver packs or external bec's and can be plugged in to any receiver slot. Mine has worked flawlessly with my 2271.
@mikeravain8757
@mikeravain8757 11 жыл бұрын
Yup common problem with the Savox hi torques. I'm going to start to waterproof min savage, so I used the Savox sw0231mg. It's just over 200 oz/in and costs less than $50. Mamba monster 2 is next woot!
@EMAXXMASTER
@EMAXXMASTER 11 жыл бұрын
Savox are awesom. Just power hunger. Ihave them in all my cars
@mikeshobbiesandrandomstuff
@mikeshobbiesandrandomstuff 11 жыл бұрын
the one on my vorza was the same way until i noticed that for some reason it was set to four volts and according to factory spec it should be set at six so i set it with the castle link and it was like i had a totally different servo in there i am now able to push the nose of my vorza to the floor and the servo keeps on whipping those wheels...but just for a little more power some day i too may swap it for a savox
@Leprechaun79
@Leprechaun79 11 жыл бұрын
I haven't needed to add a cap to any of my RC's yet with the Savox servos. However, I only have three cars with them right now.
@victorm316
@victorm316 11 жыл бұрын
Thanx bud
@mikeshobbiesandrandomstuff
@mikeshobbiesandrandomstuff 11 жыл бұрын
this is very true!
@kimdra9321
@kimdra9321 11 жыл бұрын
Ey yo dis savöx 1256tg servo it's very nice;)
@EMAXXMASTER
@EMAXXMASTER 11 жыл бұрын
U dont even need to buy a receiver cap. Just get a 4700uf cap and a 2pin soldering its cheaper ;) just my input
@victorm316
@victorm316 11 жыл бұрын
Pretty much use what i did and it will work perfect. The stock bec system with the castle creations. Just get a cap
@eostrow1963
@eostrow1963 6 жыл бұрын
Sf50 is a 266 Oz servo.
@victorm316
@victorm316 11 жыл бұрын
Yea, U can set it on 5v or 6v, I have it on 6v. Thanks for the info though.
@victorm316
@victorm316 11 жыл бұрын
Thanx but i know that, Its on 6v. Not enough my friend. You need to get a cap with a savox
@victorm316
@victorm316 11 жыл бұрын
HPI savage flux xl all the way bro., OMG
@monkeyguy80
@monkeyguy80 11 жыл бұрын
Mine already changed to savox 1256tg servo! Yeah...I've to agreed with u hpi flux servo dam sucks only can driven awhile & it bang!
@TheAlpcan08
@TheAlpcan08 11 жыл бұрын
good work guy.. now i wanna use tg 1256 on my savage flux hp with stok radio system tf-20u. what do u advice for this system.whats like bec system i have to use (or i dont have to use)?if you help me i glad u.thanks so much..
@eostrow1963
@eostrow1963 6 жыл бұрын
I will be upgrading to a savox 500 Oz servo..
@1997LT1Camaro
@1997LT1Camaro 11 жыл бұрын
Also forgot to mention I have castle link software, and thought I remember seeing a setting about servo voltage. Do you know if this a way to send more volts to servo by chance?
@victorm316
@victorm316 11 жыл бұрын
Thats true. I bought my first savox servo for my super flux and I fell in love ever since. lol I just have to add these caps to my receivers to make them work as you can tell in the video. Did you have to do that to any of your brushless vehicles with a savox?
@victorm316
@victorm316 11 жыл бұрын
U can plug it in the bind plug spot. Doesnt matter.
@EMAXXMASTER
@EMAXXMASTER 11 жыл бұрын
Haha very true. Do u run a receuver cap with ur 5b savox?
@paadventureland3315
@paadventureland3315 11 жыл бұрын
That transmitter on the table can it work for the xl stock or do you need a different receiver ?
@1997LT1Camaro
@1997LT1Camaro 11 жыл бұрын
How many channels does the receiver have to have to use the voltage capacitor? I think my receiver only has throttle and steering. (it also has the jumper pins also)
@XNeo27564
@XNeo27564 10 жыл бұрын
Hey brother, I have a question, I´m rebuilding my savage X Nitro and need/want 3 new servo´s which need to be waterproofed 1 for reverse 1 for gas 1 for steering. What would you recommend? Also you think its safe to use an 7.2 volt 1100mA 2 cell lipo as humppack? I tested it fast, and saw my failsafe light up,+ the brakes jumped on, but I was scared maybe to fry the receiver :P so left it on 5 seconds only.
@victorm316
@victorm316 10 жыл бұрын
Hey wutsup?. You can only use a lipo batteries if the servos are hv, (high voltage). Ands I'd you'd receiver can handle it. Like spektrum or futaba. Idk what your using. Personally, I like Savox servos. And they do make Waterproof. For braking and reverse and its waterproof and hv. Look up savox sw-0230mg. I would go on savoxusa . Com. And see what you like. Hope this was helpful. Cheers
@victorm316
@victorm316 11 жыл бұрын
Yea its quick
@victorm316
@victorm316 10 жыл бұрын
No I didn't. I just left the stock gearing. Which is fine. Wouldn't go any higher. And thank you
@englandstillhasit
@englandstillhasit 11 жыл бұрын
dude its savOX not savex. I havent seen that one yet i have the 1256tg they are alittle twitchy but only because there so precise there always searching for the pin point centreing they calm down once theyve found the centre. But im thinking about trying the xo power s4030d servo itss $23 and has the same specs as that 22kg / 0.15 sec there on hobbyking under hobbyking servos i have a quarter scale xo power servo and its been sweet so far.
@supermegarc9895
@supermegarc9895 5 жыл бұрын
Why didn't you show it being taken apart
@wogzcok6104
@wogzcok6104 9 жыл бұрын
Hi mate...what model is that proline body. It fits the XL very well and want to grab one. Cheers
@victorm316
@victorm316 9 жыл бұрын
Hi. This is the Ford F350 body from proline. And yes. It fits the xl perfect.
@wogzcok6104
@wogzcok6104 9 жыл бұрын
Rc FPV Basher thanks mate...is it made for the xl specifically
@victorm316
@victorm316 9 жыл бұрын
Aaron Smith yes it is. I had it on an emaxx to. It was a little to big for a emaxx
@savagefluxe
@savagefluxe 11 жыл бұрын
please replay do we need the protecter because i want to buy savox servo ?
@jquintana0502
@jquintana0502 11 жыл бұрын
What spektrum receiver do you have
@fabianzula7022
@fabianzula7022 9 жыл бұрын
Which spektrum do you use?
@1997LT1Camaro
@1997LT1Camaro 11 жыл бұрын
I dont have a programmable transmitter, is there any way to set travel limits other than having one like yours?
@rodrigobautista6511
@rodrigobautista6511 11 жыл бұрын
Savage flux xl or e-maxx brushless?
@victorm316
@victorm316 11 жыл бұрын
I have a protector because it wont work without it. It will glitch and be all funky, its a power hungry servo
@douglasgarcia1315
@douglasgarcia1315 9 жыл бұрын
hi ....what servo is better for mi hpi savage flux hp?
@victorm316
@victorm316 9 жыл бұрын
you can go with the servo I used. it's about 300oz of torque. and it is pretty quick. I like savox servos. but with them. you need a glitch buster
@TheLukey21
@TheLukey21 11 жыл бұрын
you dont need to buy a 'servo protector' its just a capacitor with wires soldered to the + and - make one there so simple.
@douglasgarcia1315
@douglasgarcia1315 9 жыл бұрын
spektrum 1600?
@pete2109
@pete2109 6 жыл бұрын
Why so you say Sevics instead of Savox?
@victorm316
@victorm316 6 жыл бұрын
Pete G because I want to.
@mikeshobbiesandrandomstuff
@mikeshobbiesandrandomstuff 11 жыл бұрын
you can set the bec voltage with your castle link
@victorm316
@victorm316 11 жыл бұрын
Thats all i use is 6s, Nothing else
@RCmanfinland
@RCmanfinland 5 жыл бұрын
My clanel RCmanfinland
@victorm316
@victorm316 11 жыл бұрын
I know what it is. Why make it if u can buy it. $3 thats all
HPI SAVAGE CENTER DIFF BUILD - Part (1)
26:47
Mainerules rc
Рет қаралды 3,5 М.
БАБУШКИН КОМПОТ В СОЛО
00:23
⚡️КАН АНДРЕЙ⚡️
Рет қаралды 18 МЛН
Summer shower by Secret Vlog
00:17
Secret Vlog
Рет қаралды 13 МЛН
Spot The Fake Animal For $10,000
00:40
MrBeast
Рет қаралды 189 МЛН
HPI SAVAGE FLUX XL
19:41
EVERYDAY RC
Рет қаралды 21 М.
HPI Savage Servo Horn/Saver
9:11
KaKo RC
Рет қаралды 13 М.
HPI Savage Flux 3D construction animation
6:42
Shromilder
Рет қаралды 41 М.
HPI Savage SS 2.4GHz  & Thottle Servo Set Up!
33:44
Haggard RC
Рет қаралды 1,6 М.
8 Best servos under $100 - Torque tested and reviewed
14:41
RC Review
Рет қаралды 116 М.
TRAXXAS HEX ON A HPI SAVAGE FLUX XL MODIFICATION
7:26
Fun Gaming And R.C.
Рет қаралды 14 М.
Savage Flux HP - Bashing Upgrades
7:05
WCarrollX
Рет қаралды 14 М.
Hpi Savage Flux XL Fully Upgraded
17:08
RC’s Finest
Рет қаралды 2,5 М.
📱магазин техники в 2014 vs 2024
0:41
djetics
Рет қаралды 479 М.
ноутбуки от 7.900 в тг laptopshoptop
0:14
Ноутбуковая лавка
Рет қаралды 3,4 МЛН
Как бесплатно замутить iphone 15 pro max
0:59
ЖЕЛЕЗНЫЙ КОРОЛЬ
Рет қаралды 8 МЛН