We went from the 362xp to the 562xp back when they came out. We used them for crane removals. After you finished the cut off and shut the saw off I’d just switch it to high idle right then so next cut I could pull it up by my lanyard and pull it over. It would start one pull every time. Once you did it a few times you never thought about it.

Man, my buddy owns a tree service and one of his guys bought a 562 mk 2. We've put that saw (stock) up against a stock stihl 362, stihl 400c and my Husky 555 and it crushed them all.

Cool video. Good to see a saw cutting that is not very common.

Very nice builds! That 562 is a bad ass running and looking saw! I have a 562xp just muffler modded great little firewood saw! That 6510 sounded like it held its grunt while loaded up great job Boedy!

Both of em are very nice saws and both run stellar!!!

Did you say you get 200$ a month from us ? God damit I’m going to bump up to the next level. I’m not swinging in money,drowning is probably the better term but I enjoy your channel and it’s not even close to buying you a beer these days. Anyway thanks for your time and effort body! I now that doesn’t help pay for anything in your life but at least you can feel a little better knowing you’re appreciated. Keep it up big dog!!

Sounds like the EFCO might be slowing down just a bit which starts climbing back up the torque curve making it feel stronger where the Husky has enough torque to stay at the upper RPM.

Keep running that 562 it’ll find itself. ⭐️⭐️⭐️⭐️⭐️

Damn Boedy. If it is pretty much keeping up with a ported 562 you did a good job on it. Especially for the first time porting one.

Nice work!

Great job on both👍🏻 the Efco is holding it's own, but that 562 is slick!

I rattle canned my OE 372 the same but damn that 362 looks good. Thanks

Look at how straight that cookie log is.

Damn kinda like the efco man

I really like that 562. I wonder what hp number it is putting out.

What happened to the 254xp on the wemar build?

Don't really care who is faster all that matters is who will finish the job at the end of the day with less problems or no problems at all.

👍👍

The ms400 is a bigger saw then the 562. If you want to compare like saws then get a ms362 to compare to the 562. Cause the ms 362 and the 562 are the same cc and saw class. where the ms 400 is a higher cc then the 362 which gives it more power right off the bat, then you ported it.

The Husky is impressive for its class. The ms400 should out cut the 562. It has more cc's. Not alot more but enough you should notice a difference. With that said the ms400 does punch well above its class.