Ten times more engineering and work than I would have guessed.
@moondog7862 Жыл бұрын
Shocking cable preparation, crossed screenwriters, scored the conductor with a knife too😂😂
@mahendrangm47065 жыл бұрын
Wow super...
@douro203 жыл бұрын
I'm guessing that the heating step is to ensure that the core is completely dry before installing the termination.
@VienDuHoang3 жыл бұрын
It might be one of the reasons, but the main reason is to make the cable straight and even, before installation.
@zizizizi17093 жыл бұрын
110кV? What type is that termination? connex5? connex6s?
@hkvlog41433 жыл бұрын
Im a asistent cable jointer and have a experience of six years on 132kv, 220kv,400kv. i worked in qatar for six years. If you need asistent cable jointer then i would be much happy to work with you
@VienDuHoang3 жыл бұрын
Thank Khadka. Actually, I'm in Viet Nam. But should I have any job, I would let you know. Thank you.
@hkvlog41433 жыл бұрын
@@VienDuHoang Thankyou sir , this is my email id = Harikhadka414@gmail.com
@Jim1Guo2 жыл бұрын
Looks like dry type plug-in termination
@aqibbajwa20034 жыл бұрын
Which accessory this one?
@VienDuHoang3 жыл бұрын
3M my friend, it is HV cable accessories.
@bluesignal23342 жыл бұрын
How much hours it takes for one termination
@sergeignatievsky49552 жыл бұрын
More than 1
@hkvlog41434 жыл бұрын
Round cuter no have
@aqibbajwa20034 жыл бұрын
Hi guys way not use cable streping machine to save time
@VienDuHoang3 жыл бұрын
the semi-con bonded to XLPE layer, no cutting machine could remove it evenly, and might make the XLPE thinner by removing too much of the insulation. Glass cutting is the safest way, but time consuming.