Hydraulic Tensioning Procedure

Рет қаралды 20,216

Күн бұрын

A step by step look at basic hydraulic tensioning procedures from safety and setup to installing and loosening fasteners.
0:00 Review Tensioning Safety
1:23 Identify and Inspect Equipment
2:26 Verify Tensioning Parameters & Equipment
3:10 Prepare Flange and Bolts
4:19 Setup and Test Electric Pump
6:18 Install Tensioners
7:03 Install Hoses
9:09 Tensioning Group A
11:05 Tensioning Group B
12:43 Loosening with Tensioners
Learn more about:
HYTORC Hydraulic Bolting Tools: www.hytorc.com/hydraulic-tools
HYTORC Tensioners www.hytorc.com/tensioners
HYTORC Pumps www.hytorc.com/pumps
The HYTORC Standard
Through superior Quality, Technology and Support, HYTORC will deliver you drastic safety, quality and job schedule enhancements! Learn more about The HYTORC Standard and about our award winning products at www.hytorc.com/

Пікірлер: 12

@nengibenstowe1130 Жыл бұрын

I love this job

@trinidattobago7435 3 ай бұрын

Great video!

@KuntChitface Жыл бұрын

sick

@aravindvkumar630 10 ай бұрын

👌

@PaulDanciu 5 ай бұрын

what is difference between pressure A (it is the final target?)and pressure B how much % need to be applied

@Lokeh81 Ай бұрын

When working with tensioners like this, our goal is to end up with a preassure close to, or slightly higer than B. Ax3+Bx3 = close to B. Your equialized preassure between A and B. So, if you move one of the tensioners back to a random A-bolt and test it, if you have done this correctly, you'll see it releases close to B. if not, if the preassure is alot higher than B or alot lower than B, you need to start all over again.

@alvarooryan3084 19 күн бұрын

When tensioning in 50% configuration, Pressure A is Pressure B x CLF. Cross Load Factor (CLF) can range from 1.15 to 1.25 Pressure B is calculated considering the residual load x LTF (Load Transfer Factor). the LTF depends on the grip length or the effective length of the joint and the bolt nominal diameter LTF=1.01+(diameter/grip length).

@mr.known0 8 ай бұрын

Can we use same procedure in any count of bolts

@Lokeh81 Ай бұрын

When working with tensioners, its always 1 out of 2 procedures. What we call a 50% tension procedure or 100%. So tools on half of the number of bolts, or tools on all. No more, no less.

@Lokeh81 Ай бұрын

and if you use 100% tool precedure, you do not need the A preassure anymore. Just go for B x 3.

@Lokeh81 Ай бұрын

This is misinformation. Its VERY important that your bolts gets to rest between your cycles. If you preassure to A, turn the nuts and release preassure, the bolt will need around 30 mins to return to its original form. If you dont let your bolts rest between cycles they will not be tensioned any more and the nuts will not turn on cycle2, or 3.

@Lokeh81 Ай бұрын

According to EN-ES 1591-4