Mine is so bumpy too. They’re really good trucks and they fire up so quick even when it’s freezing out. That’s the truck that got me started in shed hauling.

Engine sounds realy tight and good yehaaaa .

Prettiest slick Andy that will be a cool project. Great find👍

Hello Andy, I've been busy lately! We have two of those DT466 here at work, the m/t one is great but one has an a/t and it's lost reverse. Everyone around here says replacing it is a waste of time because they're all eventually going to do the same. And rebuilding it seems to be a task no one wants to take on. I'd love to put another trans or drive train under it and turn it into a dump truck one day. It's just sitting now collecting dust.

Got my International S series project on the road last fall, has the DT360 engine and Allison tranny , also a 10 foot dump bed. Handles real well and have hauled quite a bit of rock with it since. I had to remove the cab and rebuild one side of the cab main support rails, but not too bad a job. Cab had settled and was bumpy like yours . I cut the whole support rail out and fabricated a new support from box tube and angle iron . The front mud flaps on the International collect junk at the top support and cause the cab support to rust out -- all repaired now

Hey Andy! Nice buy my friend 😁👍 Yeah the frame is crusty but when shortened, it will make a great dump truck. Never seen an air seat like that. Take care and happy wrenching 🔧🔩

Thank you for the video

Another good video Andy I believe that seat cushion on the passenger side is removable 👍🇺🇲🚛👏

You better take the axle off the springs and cut the frame behind the cab then make your own frame out of 3/8 sheet metal which is bent to match the cab frame then put air bag suspension and possible air brakes. I suggest you have the bed made a little longer than a standard bobtail so you can haul a little more than a standard bed wood haul. I say all this with young in cheek so have fun building this truck!!!

That shit is toast

Margret's gonna get jealous.

It is best to replace the chassis

If you put a 10 ft dump on there the frame will be cut anyway just add a proper hitch

What year is it? I have an 07 7400 with dt466 engine tandem dump with air brakes automatic.

I'm hoping you got a great deal on that truck, because I don't think it'll pass d,o,t, with that rusty frame. I don't think you ever said what you paid for it to be able to say of it was a "good buy", but if you go off of the auction sites like "big iron" or "truck paper", I'd say it's worth about 5 grand, any more than that, I'd pass

You need to learn how to float the gears just rev it up till you think it needs to shift and shift with no clutch I drove a truck for 25 years Ben in every state but Alaska never had any clutch problems makes driving a lot more fun

Truck was riding so “bumpy” because the tires are cold. Once they heat up they soften up.

To much rust to much work to repair need a new rear section frame forget about patching to much patching welds weaken frame cause frame rails are harden steel heat and welds softened the weld areas the weight you will be putting on truck has to be taken into consideration hope this helps those out there.

I hope you can learn how to float gears by the way my name is James