In this week's episode of "I Carry," we have an FN America Reflex 9 mm pistol carried in a DeSantis Inside Heat holster with a Shield Sights RMSc red-dot sight.
Firearm: FN America Reflex MRD (MSRP: $659)
We’re taking another look at FN’s entry in the micro-9 mm double-stack pistol market, the FN Reflex today, as it represents another option for those looking for a pistol that is easy to carry, yet offers decent capacity. This market segment started to really take off with the introduction of the SIG Sauer P365 and Springfield Armory Hellcat, and most major manufacturers are offering their take on a pistol that’s sized in between compact and subcompact.
The Reflex is right in the middle of this category: 3.3-inch barrel, 6.2-inch overall length, 1-inch width and a weight of 18.4 ounces. Overall capacity is 12 rounds with the standard magazine and 16 with the extended variant; both magazines allow a full, three-finger grip on the pistol, but if the flush-fit floorplate is used on the 11-round magazine, the pinky finger of the strong hand will wind up curled under the magazine. Given the miniscule amount of space saved by going with the flush-fit floorplate, keep the floorplate with the finger extension to get all three fingers on the grip.
One area where the Reflex departs from its micro-9 mm double stack siblings can be ascertained via the rear of the slide. Where most other pistols have a removable plate to access the striker, the Reflex does not-because it has an internal hammer rather than a striker-fired system. This allows the Reflex to have a smoother trigger pull than striker-fired offerings, in addition to making the Reflex easier to rack than pistols with stiff recoil springs, especially those often found in small, 9 mm pistols.
We have the MRD variant, for Micro Red Dot, for today’s kit, and FN has cut the slide for both the RMSc- and Holosun K-series footprints. This allows a wider variety of small red-dot sights to be quickly and easily added to the Reflex should that be desired. Simply remove the cover plate, align the optic, and secure as needed. Some of the smaller sights have the battery located on the bottom, meaning it will need to be removed from the pistol. In cases like this, it’s easiest to torque the sight down and mark the screws with a witness mark, as it makes removing the optic easier when it’s time to replace the battery. With the footprint milled directly into the slide, the sight will sit as low as possible and may even allow co-witnessing with the iron sights.