I went too far really, it should tighten up on the threads and not go that far down but I hope everyone gets the idea.
@lilmarce078 ай бұрын
Can you check your work when doing this? Like pull the tap, then screw on the NPT fitting? And if it’s not far enough down, go back and tap again? Or not recommended?
@CarportGarageDragRacing8 ай бұрын
Yes I would definitely do that.
@CarportGarageDragRacing8 ай бұрын
I would encourage it.
@The1mybuddy12 ай бұрын
What are fittins?
@CarportGarageDragRacingАй бұрын
Like fixins my grandma use to make with dinner :-)