I make a Twisted Steel Rebar Industrial Style Handle. I love the look of industrial furniture and all the decor that comes with it, and this handle has the look I like. I hope you enjoy my video of the metal twist handle, it was a lot of fun to make a nice MIG welding project.
The wide flat bar is 6mm thick, 50mm wide, and 225 long. The small flat bar is 6mm thick 32mm wide and 57mm long. The rebar is 7mm rebar. The distance between the two uprights is 145mm.
The main tools used, are a MIG welder, angle grinder, drill, and bench vise.
Tools / Supplies, I often use are.
Marking out Tools
Markal Silver-Streak Metal Marker Round: amzn.to/3mTJDHt
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: amzn.to/2WKKpeE
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: amzn.to/3kHrXfo
Locking Pliers - Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: amzn.to/3zzJH2u
Milwaukee 6" Long Nose Locking Pliers: amzn.to/3jyVLeS
Milwaukee 6” Locking Clamp Regular Jaws: amzn.to/3jB94eI
KNIPEX Tools Long Nose Grip Pliers: amzn.to/3ByD1SP
Magnets
Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: amzn.to/3DCya4W
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: amzn.to/2WN9Fkr
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: amzn.to/2YaZXsU
My camera set-up.
Canon EOS M6 Mark II Camera 15-45mm Lens: amzn.to/3DNnn83
VideoMicro Rode Compact On-Camera Microphone: amzn.to/3QkUBnK
Camera Tripod Vanguard Alta Pro 2: amzn.to/3yB8hP5
The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: alphatools.com.au
As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar