ICT Billet knock sensor relocation bracket install 2005 Chevrolet Avalanche

Рет қаралды 10,735

2 жыл бұрын

Review and details of installation of the ICT Billet knock sensor relocation brackets (551216-KN30) and knock sensor extension harness (WEKNO30-36) on a 2005 Chevy Avalanche 4X4. These brackets are made to work with the 1996-2007 LS Gen III engine series (LS1, LM7, LQ4, LS6, L59, LQ9, and LM4) where the knock sensors are located under the intake manifold.

Пікірлер: 19

@asm255 4 ай бұрын

Im thankful for your video, i was planning on doing the relocation but after seeing this i think id rather just take out the intake manifold and replace the existing sensors 😂 especially with a 4x4 truck and all the parts in the way

@chrisinestes 2 жыл бұрын

Thanks for the video. I have big arms, hands, and fingers, so I may have to find a small mechanic to help me out with this swap, but I think I'll order the parts and give it a go.

@DSCustomsInc 2 жыл бұрын

Great video. Told me exactly what i needed to know. I’m gonna gove these brackets a try

@towboysgarage5289 2 жыл бұрын

I made this video just so others could see what was involved in doing it. I hope it works out for you.

@trevor5933 Жыл бұрын

Great video. For reference, I have a 2004 Express 3500 box van with the 6.0, Neither the drivers or pass side blocks fit, because of oil cooler lines and the frame/ crossmember. I pulled an oil pan bolt and used the drivers side block with a longer bolt, seems to do just fine.

@johnleca Жыл бұрын

great video thanks

@martygrajeda3457 Жыл бұрын

Good information thank you

@markyoung1256 19 күн бұрын

Great video! I might have missed it in the video, but what did you do about the valley? New solid plate, or reapply the plugs with silicone?

@TheNiel1968 8 ай бұрын

How do we obtain the adapter kit?

@henryhenry4377 Жыл бұрын

Hi i enjoyed your video. What the name of the brackets. AND company i would like to purchase them .Ty.

@wmciii6770 Жыл бұрын

Cool video , my ? Is there any excessive revving of the engine to relearn? Most relocation videos claim 5-6k rpm for 3-5 seconds two to three times .. Tks again great video

@ahawk1968 Жыл бұрын

any idea if having a six inch lift would make the process of installing the brackets easier or more difficult? i have replaced the sensors once already, four years ago and recently started getting codes again... i dont want to pull the intake again, especially with the lift... thanks

@Jmav91 2 жыл бұрын

I bought all of this but honestly didn’t want to fool with the locations lol so I’m thinking of screwing in the knock sensors on the side of the heads the threads fit into the holes by alternator and passenger side

@towboysgarage5289 2 жыл бұрын

That's the reason I made this video, so someone needing to do this will see what is involved. It's definitely not an easy job, but doable.

@8t8GTA Жыл бұрын

Lucky I have a 2 wheel drive

@Waterskibug 5 ай бұрын

I went out and checked my 2500 Suburban has the oil cooler lines mounted in the hole on the driver side. Don't see any more holes on that side of the block.