how to diagnose a leaking Ideal logic diverter valve cartridge and how to replace one.
Пікірлер: 7
@huyongquan65543 жыл бұрын
What a smooth plumber's hand you have.
@johnconnor81622 жыл бұрын
On the new part what was that other brass nut with the o ring for ? It looked like u didn’t use it. Why is it supplied
@nickbell86343 жыл бұрын
How is the black motor box on the front connected to the valve? Looked like he just pulled it off.
@krazytroutcatcher Жыл бұрын
It’s a push fit, held in place with a sprung U clip, which looks very similar to a car door lock clip, if you’ve ever seen one, once common on Fords.
@chohanchohan82083 жыл бұрын
👏🏽👏🏽👏🏽👏🏽👏🏽🍻🍻🍻
@davidleighton17632 жыл бұрын
If you're going to show it on KZfaq you should at least do the whole job and replace the back half too. Also, if it's been leaking that much I'd replace the motor too as it's probably got wet.
@Lucasimo Жыл бұрын
That's a good point, but the part that is always going to fail eventually with a leak, is the front part as this is where the moving valve is. The back part doesn't have the same wear rate as the front.