Episode 216 - A footrest for a high chair
I need to add a feeding footrest to the Ikea high chair. On the K690s sizing saw, I edge the oak and ash waste, and then I cut to size on the planer and the ad741 thicknesser. I mark the ends of the boards for cutting on the band saw fb610. I grind the tape cut on the edge sander. I make the holes with a forstner drill, spaced a few centimeters apart. Thanks to this, it will be possible to adjust the height of the footrest. On a felder circular saw, I cut the footrest in half. I put a sanding band on the band saw and set up the sanding attachment. Thanks to this, I remove the material between the drilled holes. I set the drilling height on a horizontal drill and drill holes for screws. I sand all the elements and mill the edges. Finally, I secure the whole thing with oil-wax. I clamp the screws at the ends with a butterfly so that the height can be adjusted at any time without tools.
#mebletwojegopomyslu #mtp #wood #woodworking #footstoolchairs #felder #steblo @ MebleTwojegoPomyśl