The fence is designed to be used on the right side of the blade. The extruded fence face can be moved to the opposite side of the fence body should you need to use the fence to the left side of the blade.

Please ignore my stupidity...just realized why it wasn't mentioned...Laguna...again my apologies

Work smart, not hard. Keep the blade guard on. Scrape a line from the blade all the way to the front of the table and use it as a mark for your cuts. That way your fingers won't ever get close to the blade and you will save up cash! Thank you Laguna for the great prices and services!

Hi, you can install the router table on Fusion Tablesaw 2 and 3. Thank you.

The design and weight of the trunnion mechanism in this saw does not require the use of a tilt lock to hold the tilt in place.

Our Customer Service technicians can assist you with these adjustments. Please contact our Customer Service department at (800) 332-4094 or at customer_service@lagunatools.com

How many saws on the market now, have a fence that locks in the rear?

Good tolerances and a proper locking mechanism creates stability. With pressure from both sides on a fence that locks on the rear, a bowing or warping effect can be introduced. You’ll notice most high end panel saws only lock on the front and this is common among good saws, as the castings are heavy and accurate with a good clamping mechanism.

Thanks for your feedback! We'll take the music volume into consideration for upcoming videos!

No cc or what?