Motor Meter Racing gauge set with instrument panel: tinyurl.com/27a...
Пікірлер: 31
@jerry50bmg656 ай бұрын
Regarding the fuel sending unit, thanks for the access panel in the cab to avoid having to drop the tank.
@Kevin24Seven6 ай бұрын
Yeah no doubt! I wish they made it a little further back to you could get the whole pickup out if needed haha.
@JADA1216036 ай бұрын
Just purchased this based on your review. Thanks man.
@Kevin24Seven6 ай бұрын
Nice, hope you like it. They really should sponsor me hahaha!
@JADA1216036 ай бұрын
Lol IKR.. Just received them today, very nice....
@satyanarayanana75636 ай бұрын
Thanks a lot brother …
@mohammadelbatniji44484 ай бұрын
wow this is beyond beautiful
@mikedoherty6227Ай бұрын
I just bought a Humvee with that cluster in it. Any chance you know of an online source for the installation instructions you got? I want to look over mine and just make sure it’s good. Plus I’d like to see what’s involved in getting the turn signals to show. I didn’t even know that was a thing.
@Kevin24Seven26 күн бұрын
@mikedoherty6227 there may be something if you go to the Motor Meter Racing site but jot 100% sure. If you can find a TM diagram you may be able to find which wires to tap into from the turn signals and just wires those in. I've still yet to do it lol.
@jerry50bmg656 ай бұрын
The gauge cluster can the puzzle from hell. Take it easy.
@davesmith61286 ай бұрын
You should hook up a quality mechanical oil pressure gauge to compare. Just put a "T" in line with the stock sending unit than cap off the T fitting when done. Rule of thumb is 10PSI for every 1K RPM, Also you are assuming that since the new gauges are reading lower readings, that it is better. I.E. the coolant temp. Your thermostat controls temp. The GM motor is designed to run at 220 degrees (ish). A temp gun at the stat flange on engine would help determine. On voltage, take a voltmeter and go to the batteries and see what the charging value is when running. 29volts reading on new gauges is too high. Verify.
@Kevin24Seven6 ай бұрын
Honestly I'm not too concerned with the oil PSI but I have been meaning to do that with a fuel PSI gauge in case of any future issues it helps a lot to be able to easily diagnose. 220 degrees is one thing but 230, sometimes even 240 is too high. I had another M1123 and it would say the exact same thing on the OEM gauge. I knew the truck was not running 240 by confirming with the temp gun like you mentioned and also because it would be boiling over in all likelihood. The voltage reading is interesting, ill have to look into that.
@nickmatosian61273 ай бұрын
Just want to verify, when you say you need to touch ground to change the color. Do you need to pull the cluster to change them again or is the a way to push a button once installed?
@mikedoherty6227Ай бұрын
I have the push button light switch. I can change color by pushing gauge brite )or something like that). I’m not sure how you would do it on this install.
@williamstagina13296 ай бұрын
Where are you located in Mo. I have a humvee, have owned it for 20 years and live in STL area.
@leeBattle-yb4tl6 ай бұрын
Thanks for doing this video. I just ordered a set of these. Where did you mount the GPS sensor for the speedometer?
@Kevin24Seven6 ай бұрын
I just mounted it against the sheet metal by my left leg. Seems to work fine.
@leeBattle-yb4tl6 ай бұрын
Thanks. Also, thanks for all the great content. Watched all your stuff before pulling the trigger on a Humvee. Super helpful!
@Kevin24Seven6 ай бұрын
@@leeBattle-yb4tl Glad I could help!
@brandanbellamy43596 ай бұрын
Could you have rotated the instrument panel so the speedo was on the left side? Would have been closer to the turn signals and may be easier to see with the steering wheel. I definitely will look at this for mine.
@Kevin24Seven6 ай бұрын
Yes you can however I found that my view would be a bit obstructed by the wheel that way. The other thing is I think the back of the panel (which would become the front in that configuration) may not have quite as nice a finish but I couldn't tell for sure.
@brandanbellamy4036 ай бұрын
I gotcha - I just ordered mine, I didn't even know about these guys. And I mean to rotate the face plate not to flip it so the finish is still on the same side.@@Kevin24Seven
@Kevin24Seven6 ай бұрын
@@brandanbellamy403 sweet! And I understand now what you mean on the rotation. I don't think anything would stop you from doing that other than it would probably look a bit odd with all the gauges being near the bottom instead of the top of the panel.
@williamlopez49346 ай бұрын
Do u have the part number for this kit?
@Subgunman5 ай бұрын
Can those panel lights be dimmed? There are times when the lights should be dimmed so as to not cause eye fatigue. One friend told me that the firewall should receive two layers of Dynamat to mute the engine noise. It just occlude to me that if one checks on Amazon for RV LED light dimmer there should be several selections that come up BUT DON'T FORGET YOU NEED THE 24 VOLT VERSION. You will destroy a 12 volt version. It’s a pity that this company does not show KPH on the Speedo as well😢. Speedhut gauges are way over priced and I bet they come from similar suppliers in China. Wherever you have a captive niche market these companies will rape you on the cost.
@Kevin24Seven5 ай бұрын
Unfortunately no dimmer but that would be interesting to try one out. I am a big proponent of having the right light for night driving. Fortunately you can change the color and I ultimately went with Green which is pretty easy on the eyes even when bright. Sometimes if I'm gonna be driving for a long tike in the dark I simply turn the panel light off and periodically check it to make sure nothing is going wrong.
@DavidEAragon5 ай бұрын
Lots of good add-ons. What sound insulation did you add, where, and how much of a difference did it make? Thanks
@Kevin24Seven5 ай бұрын
It's dynamat but fair warning it isn't cheap. I would say it made a solid 15% reduction in cabin noise. While cruising down the road you can almost hold a normal conversation in my truck and while on the highway you can still talk if you yell.
@DavidEAragon5 ай бұрын
@@Kevin24Seven Great, thank you.
@OneShot03116 ай бұрын
What did you do with the stock speedometer cable? I think it would continue to spin being maniacal?
@Kevin24Seven6 ай бұрын
IDK why but that made me laugh a lot haha. Thats exactly what its currently doing and sometimes I get confused and wonder why I feel a sharp pain in my right knee and then I remember its just my speedo cable dangling there and spinning unbelievably fast as I go down the road.