In the Shop #3 Cutting Stainless Steel Threads on a Manual Lathe.
Рет қаралды 544
Күн бұрынSome basics on cutting Threads on a Manual Lathe.
It's not so much a How To Video ?? more so how you get started cutting Threads on most types of materials, including 316 Stainless Steel.
@DCT_Aaron_Engineering Ай бұрын
That's a bloody long thread Peter. Nice one mate. Aaron.
@weldmachine Ай бұрын
It was a bit of test for when you don't do this sort work that often ?? Ironically the Steel Thread of the same length was actually worse to cut ?? Thanks so much for watching 👍
@ypaulbrown Күн бұрын
Your Jabbering is very much appreciated.....
@weldmachine Күн бұрын
@@ypaulbrown At least it's good to know someone enjoys my voice over during the videos 😅👍
@ypaulbrown Күн бұрын
wonderful information on cutting threads on 316 and other hardenable material....
@weldmachine Күн бұрын
@@ypaulbrown Hey Paul. Thanks so much for watching 👍
@chriswoods2263 Ай бұрын
Great video, always interesting to see what you have going on.
@weldmachine Ай бұрын
Hey Chris. Not sure how many people are enjoying watching this series of videos ?? But, it's good to get some positive comments. Thanks for watching 👍👍
@ypaulbrown Күн бұрын
wonderful video, thank you for making and sharing, Paul in Florida, USA
@weldmachine Күн бұрын
@ypaulbrown Hopefully, the weather is a little better over in 🌞 Florida than here at the moment 🌧🌧 Of course, I know it will be 🌞👍
@ypaulbrown 19 сағат бұрын
@@weldmachine 38 c + here, or 110 f heat index......just had a cyclone/typhoon/hurricane over in Texas.......did not effect us, but tore them up......where in Australia are you, I have traveled to Queensland back in 1994 for 30 days, worked on a Cattle Station about 50 miles from Alpha, visited Longreach, Roma , Toowomba, and Blackwater mines......Australia in that area is very similar to Central Florida .......best wishes, Paul
@RustyInventions-wz6ir Ай бұрын
Just found your channel and subscribed. Very nice work
@weldmachine Ай бұрын
If you're interested, I have a few videos on my channel with a Manual Lathe, especially to do with Threading. Also, there are a lot of videos about rebuilding a Mazak CNC Lathe. I'm not sure if this is something you might like to watch ?? I try to mix the videos up a little to keep it interesting. Thanks for watching and subscribing. Look forward to seeing you in the comments 👍
@hilltopmachineworks2131 Ай бұрын
Like my mentor said " With stainless don't dilly dally around. Get in and get out. Reduce the speed and increase the feed."
@weldmachine Ай бұрын
You're definitely right about that. Either keep it cutting, or not 👍
How to cut a thread on a manual lathe (Intermediate method ideal for home workshop & hobby engineer)
Handmade Extreme
Рет қаралды 1,2 МЛН