Рет қаралды 9,751
Handmade kitchen/Dining table. We used2 short W8x32 beams to make the main section of the table frame. The bottom and top plates were cut out of a sheet of 3/16" mild steel on our JDSQUARED plasma table along with the triangular support gussets. Once we fabricated the entire table it was cleaned and clear coated using basic aerosol clear from Lowes.
The table top itself is a large piece of sycamore, unfortunately it wasn't wide enough so we had to split it down the middle and add in a small section of black walnut so the table is not about 45" wide and 7' long. We used rubiomonocoat as the finish.
If you are interested in supporting this page please check out link below
www.patreon.com/user?u=327904...