Replacing worn throwout bearing, clutch and rear main seal on a 2002 Mustang GT
Пікірлер: 17
@mattsautomotivechannel2 жыл бұрын
Thanks for the kind words. As for the clutch chatter, it is often caused by contaminated friction surfaces like oil from the rear main seal or perhaps oily hands during installation. Another thing to check would be worn or broken engine mounts, loose bell housing bolts, or a damaged clutch cable and linkage. Best of luck! Have a great day!
@christopherholden40242 жыл бұрын
Loved every minute of your video. Very knowledgeable. I had the same kit installed in my 01 gt. I do have a good bit of chatter though. What would you recommend sir?
@cpu644 ай бұрын
My car needs that service, id love to do it but, without a lift...
@yaviermustang2012 Жыл бұрын
thanks so much for your video im in half of this job on my 97 cobra
@Sgodi32 жыл бұрын
This video helped a lot with my 01 Gt thanks ! Did the clutch kit come with a metal spacer that for inside of the throw out bearing ?
@jamesa6272 Жыл бұрын
Great video!
@mattsautomotivechannel2 жыл бұрын
This particular kit did not come with a spacer, I have seen them for hydraulic systems on the slave cylinder, but not for cable systems. Did your kit come with one? If so, what kit did you purchase?
@antoniocantillano79702 жыл бұрын
Good Job sr.
@fairfax_fran5109 Жыл бұрын
I would like to know how much you charge your customer for the job
@michaelmendez94232 жыл бұрын
Hi matt thoroughly enjoyed the video just one question though. What type of grease is used when greasing the splines and input shaft and all that?
@mattsautomotivechannel2 жыл бұрын
I used a wheel bearing grease but you could use brake caliper grease as well, so long as it is made for high temperature, because you do not what the lubricant to turn thin when it heats up and drip off. There is also a specific spline grease for this very application that is included with some clutch kits and if not, you can purchase this grease at most automotive part stores.
@firegod117 Жыл бұрын
@@mattsautomotivechannel Hey Matt, I cleaned the pressure plate with Brakes Clean and wiped with microfiber cloth so there should be no oil whatsoever. It did leave tiny little hairs from the cloth all over it but I already put it all together. Is this a concern or will it be ok. Also I torqued the bolts to 30flbs even though it says 24. I don't think it has to be exact, the bolts didn't break or strip out the threads.
@krummp67022 жыл бұрын
Matt! This video was helpful. Where are you located? I’d like to come in for some help with my 02 Gt.
@mattsautomotivechannel2 жыл бұрын
I am located near Portland Oregon, however will likely be relocating to Texas soon.
@mattsautomotivechannel2 жыл бұрын
Thanks for letting me know it was helpful, its a great motivator to keep the channel going.
@jesuslozano65162 жыл бұрын
hello, good video. what kind of clutch kit did you use?
@mattsautomotivechannel2 жыл бұрын
The clutch was a McLeod Street Pro, 10 spline, single disc, organic/ceramic clutch kit