This quick video shows the motor mounts that I got from Summit Racing and they are part of the Frame Brace Kit (#SUM-770810) and they are very simple to install.
Пікірлер: 14
@CrazyWillie01 Жыл бұрын
Enjoyed yer vid . I’m gonna have to do full floor panel , but ya don’t have a 56 chevy 2 dr wagon fall in yer lap very often😂
@ricks_garage Жыл бұрын
I'm doing patch panels in the floor and some repair on the rocker panels
@tonywest81408 ай бұрын
Nice video. Thanks for sharing. Have you mocked up the engine yet on those side mounts? Curious on how they lined up for you
@jesseparadis61414 ай бұрын
Hey is that power steering shock on center link? How does that work is it normal manual gear box still?
@CrazyWillie01 Жыл бұрын
What color is that , I want to paint my 56 2Dr wagon that exact paint scheme
@ricks_garage Жыл бұрын
This is the factory paint. It's India Ivory on the top and Larkspur Blue for the body.
@dennisrmccutcheon49109 ай бұрын
Do you think those brackets would work whit a 58 oldsmobile ?
@ricks_garage9 ай бұрын
I think they would work. I would think that Chevy and Olds would have the same frame set up.
@johnfoist28639 ай бұрын
Where did you get those side mounts?
@ricks_garage9 ай бұрын
I purchased the Summit Racing Frame Brace Kits (SUM-770810) and they came with it. I’m pretty sure I’ve seen them available separate from the frame brace.
@ronaldolweiler7745 Жыл бұрын
Would never put side motor mounts in . My 55 hdtp has a 396 4 spd for 40 years . Uses stock mounts . Never broke any , changed them in 2003 when the motor was rebuilt again .never broke a mount !
@dbwaggoner Жыл бұрын
Are you talking about the two mounts that bolt to the front of the engine? Getting ready to install a 350 in my 55. Seeing all these videos of installing these side mounts but didnt think you had to do that. I think the mounts in the back were for the original 3 speed trans. Do you still use them or did you have to install a different transmission mount? Thanks for any info you can provide.
@ronaldolweiler7745 Жыл бұрын
@dbwaggoner the two studs in the front go in the rear holes for a s.all block , the front holes for a six cylinder or a big block . Just use the stock mounts for the bellhousing. No Trans crossmember. It works fine . If you install a turbo or newer automatic Trans then I recommend putting the side mounts and crossmember kit .good luck
@ronaldolweiler77453 ай бұрын
@@bad66chevelles i have power disc brakes on the car ! With a dual master cylinder ! All gm impala parts . Before there were kits we went to junk yards and found parts that fit .