Installation of the BLUM Movento Drawer Slider

Рет қаралды 10,912

Күн бұрын

In this video, I show you how to install the Blum Movento undermount drawer slider.
Not sponsored links: some other shops will also have these products!
Slider
15" MOVENTO 763H Full Extension Soft-Close Undermount Slide Blum 763H3810S
www.woodworkerexpress.com/sli...
Locking Devices
Blum T517601R Right Hand MOVENTO Standard Locking Device, Side-to-Side Adjustment
www.woodworkerexpress.com/sli...
Blum T517601L Left Hand MOVENTO Standard Locking Device, Side-to-Side Adjustment
www.woodworkerexpress.com/sli...
Screws
Blum 606N-100 #6 x 5/8 Deep Thread Wood Screw, Phillips, Bulk-100
www.woodworkerexpress.com/blu...
Blum 661.1450.HG #7 x 14.5mm Deep Thread System Euro Screws
www.woodworkerexpress.com/blu...
Drilling Jig
www.rockler.com/rockler-jigit...
My How-to-Videos
Drawer handcrafting
• Tips and Tricks - the ...
The high cabinet - Part 1
• DIY - top of the line...
#tutorial, #woodworking, #wood, #building, #furniture, #doityourself, #diy, #howto, #slider, #drawer

Пікірлер: 10

@Gazman299 18 күн бұрын

The cabinet looks really nice. Thumbs up.

@catherinemorrison8930 3 ай бұрын

This video was super helpful and entertaining! Thanks!

@helenacalleriza679 9 ай бұрын

Great video, thanks for sharing and explaining. I didn't find the links :)

@missionwood 9 ай бұрын

You were really fast, faster than me. The links are in, now. There are also other shops that will offer this hardware. Comparing is always good. If you find a better place, please let me know.

@helenacalleriza679 9 ай бұрын

@@missionwood haha! Thank you so much. I will let you know for sure 😊

@joshsmithward8848 9 ай бұрын

Great stuff. Thanks!

@missionwood 7 ай бұрын

Happy you like it!!

@gerardswaen6885 2 ай бұрын

Thanks for the instructive video. A question: Do you place the lower slide on the bottom of the cabinet? Or do you leave a 3 mm gap?

@Gazman299 18 күн бұрын

From the other videos that I've seen everyone (but this fellow) starts with placing the first drawer slide on the very bottom of the cabinet (no space in between). Then they install the first drawer. After that they put a piece of plywood on top of the drawer as a spacer, and then use it as a jig to install the next set of slides, and so forth all of the way up insuring that everything is square to the cabinet. I'm going to install these drawer slides next month, so I'm checking out every video that I can find. I've been using side mount slides, but want to improve.

@gerardswaen6885 17 күн бұрын

@@Gazman299 The problem with using the lower drawer as a base for the second drawer, and so on is that if you make a small mistake in the second drawer this will continue with all higher drawers. I made a simple jig (simple piece of wood with holes to indicate the front hole to screw in for every drawer). This jig was a help, because I made three drawer cabinets for the same kitchen, so all drawers were at the same position every time