Installing a high performance carburetor on 80cc motorized bicycle

Рет қаралды 25,530

2 жыл бұрын

Пікірлер: 67

@benhickman5492 Жыл бұрын

I was having a hell of a time getting the slide to function properly. I was shown a different way to run the throttle cable, I feel like an idiot now. Thanks for the detailed video.

@jrock420cfh Ай бұрын

I appreciate you taking the time to fully explain everything as you were installing this. I opened the first video that popped up from bikeberry, and they had it all wrong. Their advice was to use thread tape to hold the piece in, where you just showed us how to take the old one off the stock NT carburetor instead. But what really blew my mind was the way they installed the throttle cable onto the slide. Your way was the right way. Their way was completely backward. Again, thank you for a very informative and very descriptive instructional on the correct steps to take. I bought the carburetor on Amazon, so I'm going to leave a review and I will be directing everyone here to your video for instructions on how to properly install it so they don't do what I did and waste a few hours on some other Joker's video

@motorizedbicyclerider5296 Жыл бұрын

Nice work 🚲💨💨💨 and good info 💨💨💨💯🤙👍

@icft6183 Жыл бұрын

Thanks man I appreciate it

@lawrenceregan2830 9 ай бұрын

I use this same carburetor for my Phantom 85, no rejetting or anything, put new life in the motor

@jordananderson8299 11 ай бұрын

Just bought one hopefully it's as good as yall say it is

@glennkometscher7928 11 ай бұрын

I can't get mine to stop flooding there no way to a just float my had bottom gasket missing I looked line for the gasket only thing I found was nt gasket for 36.00 + 36.00 for shipping other's I really liked the carb

@jordananderson8299 11 ай бұрын

@@glennkometscher7928 Did you contact the seller? It may just be bad luck on your part and there may have been an error in assembly

@kingearrape3488 2 жыл бұрын

thank you so much

@icft6183 2 жыл бұрын

No problem 👍 if you have any questions just ask and I'll do my best to explain

@tiagobraga1480 7 ай бұрын

I cant get the auto choke to work

@kid-red 4 ай бұрын

Thank you very good

@joelpetersen7315 Жыл бұрын

We’re can I get the small link insted off the turning on my cable ain’t long enough

@nataliejensen5941 Жыл бұрын

I bought the same one can’t get it to work been trying for almost a week now it was trying to start yesterday but would die as soon as I touch the throttle any ideas on why?

@presiqn05 3 ай бұрын

if rain, won’t water get in trough this sport filter?

@DylanSchmidt-gu2sx Жыл бұрын

I changed jets from the stock carb and my engine cuts out at around 50km an hour. Do I need a bigger jet? Much appreciated -Dylan

@samanthacollins4389 Жыл бұрын

The stock ones are just as good.

@jordananderson8299 11 ай бұрын

My stock one bogs at full throttle

@jlovee2211 Жыл бұрын

I put it on and the the throttle had more wire left so it was loose

@jordananderson8299 11 ай бұрын

It should have the metal piece on the top. Some of them will have a longer curved pipe on it. There is also an adjustment you can make from there and at the handlebar grip

@jakerook6248 2 ай бұрын

I've been looking at getting one for my bike, but the plastic intake cover on the original motor had to be cut out to fit on the steel Schwinn frame that I'm using, so I don't think it would fit 😔

@logandurbin7496 2 ай бұрын

Bro I must be tripping I got the throttle the gas n everything set up but mounting it I. The Moyer the pipe is way too lose even when I tighten all the way what do I do

@Westhelockpicker Жыл бұрын

It looks like it can tighten on the intake without having any vacuum leaks

@jordananderson8299 11 ай бұрын

You sure air doesn't get sucked in from the throttle top?

@Westhelockpicker 11 ай бұрын

@@jordananderson8299 yea

@matthewcook4955 Жыл бұрын

Most crucial part was off camera 😢

@jordananderson8299 11 ай бұрын

Which is...?

@phoenixarizona8441 Жыл бұрын

I have the same HP Carb

@kachiskid Жыл бұрын

Great job bro. I will be duplicating this process for my viewers, but will give to FULL credit for teaching me! Sub #254. Good luck with your channel.

@icft6183 Жыл бұрын

Thanks bro I really appreciate it. If you have any questions just let me know

@kachiskid Жыл бұрын

@@icft6183 Will do. Again, GREAT JOB YOUNG MAN!

@kachiskid Жыл бұрын

As promised...kzfaq.info/get/bejne/lbt4eMWe28jdlY0.html

@mikeholcombe6461 Жыл бұрын

My piece from stock was smaller will that cause high rev at idle?

@icft6183 Жыл бұрын

High rev is from air leak, idle screw, or oil gas mix is off. Most common problem is idle screw is to far in

@arcly565 Жыл бұрын

Does any one know how u can find the jet needle in these carbs as i cant seem to get them out

@icft6183 Жыл бұрын

Should be in your carb bowl

@mattyr.4328 2 жыл бұрын

Hi,what is differend between NT?HP got a more power?

@icft6183 2 жыл бұрын

Adds a little bit more air flow to the motor. A lot better quality than stock

@mattyr.4328 2 жыл бұрын

@@icft6183 Thx

@qasimali3730 10 ай бұрын

You know how you said u won’t ever need it what is your stock carbs one is broken

@qasimali3730 10 ай бұрын

Coz mine kinda is

@michelmullaney3641 6 ай бұрын

Hi I’m hoping for some help here. I have the high performance carburetor. I took my bike out for a ride and the part that mounts to the engine, it snapped and I’m guessing from the two stroke rattle..has anyone ever had this issue?

@circleball 2 ай бұрын

Those tabs break every time. I have bought about 4 or 5 of these carbs now. I finally gave up on them. I love the performance though. I have not tried using the billet intake that fits those carbs perfectly. Perhaps one last time with the billet intake.

@arvincasanas9976 Жыл бұрын

What's your idle setting for this carb? I have one but the motor keeps shutting down

@icft6183 Жыл бұрын

Each bike is different. You have to know what you're listening to in order to tune it

@mikedavis7455 2 жыл бұрын

Link to that carb?

@icft6183 2 жыл бұрын

Racing Carburetor 2 Stroke Carb Carburetor with Air Filter for 80cc 49cc 66cc 70cc 2 - Stroke Engine Motorized Bicycle Bike - Blue by #IVONNEY a.co/d/08c3QBn

@4514rooster 9 ай бұрын

Just tried installing this one and leaked gas all over the place idk maybe I got a defective one I have tried everything still leaking

@anamaul1318 Ай бұрын

Check your fuel line it might be too big i had to go a size down for mine. Make sure you zip tie the ends to make sure its nice and tight

@thetoxictraitor1024 Ай бұрын

I’ve bought two now thinking the first one was defective but they have both started leaking gas everywhere, did you ever find a fix for it?

@anamaul1318 25 күн бұрын

@@thetoxictraitor1024 how i fixed the leak on mine was like this. Barely open the valve for gas to get through. So slowly turn the knob until you actually start seeing drips. Once you see stop and look and you’ll probably find its your fuel line. The one i was using was a size up from 3/16. It was too big even with clamps i was still leaking gas. Drop down to a 3/16 fuel line size and no more leaks. If your carb is leaking gas its because the fuel line isn’t set-up right or the bowl is full in which case you need to run it without your fuel line off. I’ve done that it just starts up for a hot min and then dies because it used up all the fuel in its bowl. Don’t forget to turn your gas off so that doesn’t happen