These didn’t come with any directions so I had no idea what I was doing 😂
Пікірлер: 13
@johnnyjimj6 күн бұрын
Nice video 👍. For those wondering, the OEM foglights are NOT immune to getting full of water or corroding due to water condensation, mine did, so I'm defenitely not going to replace them with new OEM ones and will go aftermarket. However I wish they made fog lamps like in the old days, using sealed beams - those never get water or condensation. I found the OEM Honda Fog Light design quite poor for maintenance - you practically need to remove the bumper to replace a burnt bulb (by the time it burns out the screws are too corroded and you end up having the remove the bumper anyway) and the inside is impossible to drain if water gets in - the glass and housing are in one unit, cannot be taken apart. I'm looking for a waterproof LED aftermarket design at this time.
@arimanessis5752 ай бұрын
Thanks for sharing, I’m gunna try setting mine up this week. where’d you get that cool grill cover from?
@paulbateman3654 Жыл бұрын
Use a switched live from the ignition, this will then turn off the lights when the key is removed.
@impdom35562 ай бұрын
Where was the light purchased? And does it still hold up?
@canuckfixit77222 ай бұрын
A job well done! I see that you didn't bother trying to unbolt the two speed clips at the bottom of the bumper - these get hopelessly rusted up. Also, with the way you cut out only the disks, you can't access the alignment screw after installing. Look closely, there's a factory line in the inside at the top of the port that guides you to cut out a U-shaped piece to allow access to the alignment screws after installation is complete. kzfaq.info/get/bejne/Y9aKYJuJ3crUgKs.htmlsi=LHQe3MzsqNnJevNq However, if you only cut out the disks, you have the advantage of being able to remove the fog lights and glue the disks back in to restore the appearance of the bumper, effectively "reversing" the installation. I have a Honda OEM/NOS fog light kit and will consider only cutting out the disks as you have done.
@latinrider1809 Жыл бұрын
not bad,.. im also from NYC and have an element,.. the yellow connect it to a wire that doesn't use direct electricity, or you will drain your battery...
@pnw_element9822 Жыл бұрын
Nice 👍🏽
@brianthompson9241 Жыл бұрын
Please update us after it gets wet. I would love to know if this keeps the water out. I have the same aftermarket fog lights & hate the water in them.
@AlexKolipinski9 ай бұрын
No water. It probably helped that I sealed the lenses
@ttowen022719 ай бұрын
How is it holding up
@knevil7539 ай бұрын
whats the verdict? any issues?
@AlexKolipinski9 ай бұрын
No issues! The second day there was a little bit of condensation but it went away and never came back
@scweegie6 ай бұрын
Any problem with that fog button light staying on 24/7?@@AlexKolipinski