you should use a good anti seize on that that shaft so the clutch will remain easy to remove. But great example. I have not had to do the drive belt yet on mine. I have the little z246
@simonwiggle179111 ай бұрын
Another great video Mark..
@thomasfrost699311 ай бұрын
That idler pulley sounded a bit dry to me. Maybe that should have been changed? Nice video as always Mark. Thank you.
@henrymurawskibigdogrepair11 ай бұрын
Thanks Mark nice video
@silverdragontaylir82523 ай бұрын
They say bronze bushing too long(,needs to be shorter)
@benb77272 ай бұрын
Thank you good sir.
@lmsmallenginerepair44712 ай бұрын
Very welcome
@loborobertson721211 ай бұрын
Good job
@joer4802 ай бұрын
Thanks for the video. I can’t seem to get the clutch off. When I try to loosen the bolt the pulleys move. Any suggestions? I’ve tried to hold the belt but I can’t seem to get a good enough grip.
@lmsmallenginerepair44712 ай бұрын
put some penetrating oil on pto shaft
@dylanguignion203613 күн бұрын
Exactly my problem right now. I keep turning the engine over. I tried some wd40 but was wondering if an impact would be a better choice over a wrench (would it make a difference really)?