Installing Remote Hydraulics on Ford 801 Powermaster

Рет қаралды 18,485

Fawn Hollow Homestead

2 жыл бұрын

how I installed a remote hydraulics kit on my ford 801 power master.

Пікірлер: 20

@oldironacres3264 2 жыл бұрын

Great video! I have a small farm and run two 801 PowerMaster diesels. One has the remotes and one doesn’t. I’ll definitely be checking Amazon for a kit for the other tractor!

@zimmhollowfarm8414 Жыл бұрын

I kind of doubt that Amazon would have that if you want something like that I would check yesterday tractor or Steiner tractor parts.

@joduval 6 ай бұрын

Thanks was about to ask where I could find such kit.

@85camaro57 Жыл бұрын

This is a good video, I've watched about 6 others that aren't good. One thing is not one person mentions the 5th bolt that must not be used. Also no one mentions the T valve and what it does or how the valve actually works. I just purchased one and it has no instructions with it.

@cornpop7805 Жыл бұрын

Hey everyone, don't forget to mention the tape for the 20th time!

@danielbowman4819 2 ай бұрын

Would this kit fit on a ford 8N?

@MrDdaland 2 жыл бұрын

Just wondering, where did you get this and about how much? Thinking about doing the same on my 841. Just would have to spend $5 more for some Ford red paint.......

@dustinbecwar5795 2 жыл бұрын

I bought it on Amazon for about $250. I agree on the paint too. Lol I’ll be painting it red soon

@chrisrafuse8315 Жыл бұрын

Great video and considering the same set-up for my Ford 860 and have a few questions: the lever on the valve, is it momentary or continuous? And it looks like both lines out are pressurized, where is the low pressure return line to the reservoir?

@dustinbecwar5795 Жыл бұрын

Thanks for watching. The lever is momentary on this kit. And to my understanding both lines are pressurized but one is an out line and one a return. I’m no expert tho. This was my first time installing one

@moparscot9271 Жыл бұрын

From my understanding both lines are pressure and return lines. I have a similar setup on my Ford 640 that I use for a hydraulic valve for a front mounted blade. One direction lifts and the other direction lowers with force to even lift the front wheels up. When one is pressurized the other acts as a return.

@dona6891 2 жыл бұрын

Nice video, great lighting as well. I'm not sure if I saw it right. Did you put the Teflon tape on backwards at the rear remotes? I am wanting to do the same with my 61 ford utility industrial. Have you used it yet? Nice to see you using the correct tool to loosen the boltsas well as checking the bolt length. Thanks for the tip on Amazon. Hope you can do a video on you using the remotes. Thanks again Warren in Vermont!

@dustinbecwar5795 2 жыл бұрын

Thanks for watching. I went back and watched it and I did put the Teflon tape on backwards. Oops lol still worked fine. I used it this spring to plant corn and beans with a John Deere 7000 planter. Everything worked great.