Replacing worn-out 14 year old seats in the Perodua Viva with SSCUS Sport Seats. These seats are applicable for the Perodua Viva, Perodua Myvi & Proton Saga BLM/FLX (according to SSCUS's website) so installation may be similar on those vehicles.
*NOTES*
1) Don't forget to remove the seatbelt sensor upon removing the driver's seat. In the video, the driver's seatbelt sensor wiring has been detached from its socket for years now.
2) Installing the passenger side is similar.
3) @4:28 Using a soldering iron would probably give you a cleaner cut.
4) @6:50 Reinserting back the plastic headrest guide (from @0:33) into the holes before installing the cushion is possible. In my case after reinserting it back, the cushion wouldn't sit flush at the bottom of the seat frame. Cutting off the top of the headrest guide locking mechanism may help negate that problem but I decided not to go that route
-Tools Used:-
▶1/2" Ratchet
▶12mm Socket
▶1/4" Ratchet with Phillips Head Socket
▶Needle Nose Pliers
▶Plastic Trim Remover
▶Flathead Screwdriver
#SSCUS #BucketSeat #SportSeat