Introduction to Airsoft 40mm grenades and affordable launchers.

Рет қаралды 8,708

Күн бұрын

In this video we are going to take a look at two affordable 40mm Airsoft grenade launchers, some green gas grenades, basics on how to use them and a test fire to see the effect they produce. I think they are great, not the most effective in game but certainly fun.
I don't cover every variant available here. There are vast numbers of launchers and grenades available to us airsofters but these are ones I've had experience with.
Remember to always wear eye protection and face protection when handling these 40mm grenades. Never assume they are unloaded and point them in a safe direction. Do not load these in an area where other players may not have eye protection.
Get the Cyma launcher here:
www.patrolbase.co.uk/cyma-m05...
Get the nuprol launcher here:
www.bullseyecountrysport.co.u...
Get the shower grenade here:
www.bullseyecountrysport.co.u...
Get the co2 grenade here:
www.ebay.co.uk/itm/333918118758
For extra content and to keep up to date check out the Facebook page at:
/ rockbottomairsoft
You can also find me on Instagram.
Thanks for stopping by.

Пікірлер: 37

@CaptCaveman 6 ай бұрын

Recently got the cyma pistol launcher myself and I do use masking tape over the top of the ASG shells, works really well.

@rockbottomairsoft 6 ай бұрын

I think in some cases the masking tape is better. I'm glad to hear it works well for you. I've been experimenting with 3d printed bungs a friend made for me.

@CaptCaveman 6 ай бұрын

@@rockbottomairsoft yea man masking tape works well as its strong enough to stick and hold the bbs in place but also just come right off when the gas shoots, definitely a lot cheaper than buying more bungs lol

@rockbottomairsoft 6 ай бұрын

I couldn't agree more. The cost of those bungs if you buy them is crazy for what you get.

@hamblinhomestead4046 Жыл бұрын

My friend has an under barrel unit and the multi purpose shells (same as your gold shells). He uses biodegradable bbs, not the paintballs. As a cap for the shell, he wads up newspaper, toilet paper, or even paper towels. Adds to the biodegradability instead of leaving plastic caps all over the field.

@rockbottomairsoft Жыл бұрын

That's a really good idea and would work well I imagine. I used to use insulation tape which held most of the time after firing and then could be stuck down again. A friend recently 3d printed me some biodegradable caps which I have yet to try out.

@dawsondrg 2 жыл бұрын

Solid vid!

@rockbottomairsoft 2 жыл бұрын

Thanks. I'm glad you enjoyed it.

@Mrmhibbert 2 жыл бұрын

Master Mike and 40 mike (although banned at my local field) Don't own one, but love the noise of them

@rockbottomairsoft 2 жыл бұрын

Been on the receiving end if both. It wasnt pleasant. But they are pretty awesome. They do make a distinctive noise like you say. A10 on the Airsoft field🤣.

@Mrmhibbert 2 жыл бұрын

@@rockbottomairsoft yeah my friend owns the Master Mike or I call it the Magic Mike because it makes the girls scream 🤣🤣 I think the loading process is a lot easier too. Just 1 hole to fill with a soeedloader and gas it up outside of safe zone and it's good to go. But I heard a rumour that Airsoft Innovations were going bust and that's why they never have any stock

@rockbottomairsoft 2 жыл бұрын

Hahaha. I hadn't heard that. However that would certainly explain the lack of stock. I know a lot of sites don't allow them which would make them hard to sell I suppose.

@Mrmhibbert 2 жыл бұрын

@@rockbottomairsoft just the 40 mikes I think are banned for indoor sites i think. I know that I had to buy my tornado 2 from a friend who had a crazy amount of them. But they are definitely worth the money

@rockbottomairsoft 2 жыл бұрын

Yes I like the tornado 2. I have the original but to be fair I don't use it that much. Still a very cool device though.

@hodd. 2 жыл бұрын

Great video, do you know the diameter of the hole on the bung shell?

@rockbottomairsoft 2 жыл бұрын

Thanks, I'm glad you enjoyed it. As far as I know they can take a .68 caliber paintball which I think is approx 17 mm diameter(someone could correct me if I'm wrong). I know there is 3d printed options for bungs or alternatively a small piece of electrical tape works as well. Failing that replacement bungs can be bought in packs of 10 from most suppliers(think ASG branded). I hope this helps.

@berkcankucukoglu3523 2 жыл бұрын

Nice video. Just got a question for you if you ok with sharing your opinion about it... What about MasterMikes ? do you recommend those things ?

@rockbottomairsoft 2 жыл бұрын

Thanks I'm glad you liked it. I will be honest I've been on the recieving end of a master Mike but never used one myself. If they are anything like other Airsoft Innovations products I've used they will be good quality. Not owning one myself I couldn't say whether I recommend them or not. I know from the field they create an awesome spray of bb's with a distinctive sound. Stings a bit when you get hit but not to bad. I have nothing against them in game if they are used sensibly. I will maybe get one and let you know how I get on with it.

@scotthunter6179 2 жыл бұрын

Hi, what do you set the pressure to when gassing the ASG shell with co2? Cheers!

@rockbottomairsoft 2 жыл бұрын

Hi, I'm sorry I can't be more help but I don't tend to use co2 in my shell. It's capable of it but it's not something I've done yet. Guys at site use co2 and it certainly works well. As far as I know they use an adaptor with a standard co2 bulb.

@scotthunter6179 2 жыл бұрын

@@rockbottomairsoft many thanks for your reply:)

@imbluedabbadeedabbadie1674 3 жыл бұрын

Subbed

@jaredgodwin5956 2 жыл бұрын

Does the pistol one work with explosive rounds?

@rockbottomairsoft 2 жыл бұрын

If your referring to TAG rounds and that type of thing then my honest answer is, I've not tried it. I don't use tags myself. However I know that you can get a shell that will launch tag rounds. The shell fits in standard 40mm launchers and works off gas. So by that logic you should be able to. The shell is not cheap though and then you have to buy projectiles on top of that. I hope this helps.

@jaredgodwin5956 2 жыл бұрын

@@rockbottomairsoft ok thanks! Know of any launchers that are under $200 and are usually used with TAG rounds?

@rockbottomairsoft 2 жыл бұрын

I know this is a uk site but the price will come in under $200. These are generally available but I link this site as it gives a bit of info. www.airsoftworld.net/tag-innovation-co2-pro-evo-shell-launcher-single.html This is basically the "shell" I was referring to. Its the cheapest way to get a TAG capable launcher. You load this shell into any 40mm launcher of your choice like and m203 replica and it will fire exploding TAG rounds or any tag round. Hope this helps.