IPv6 SLAAC and EUI-64 Basics in Packet Tracer

No video

IPv6 SLAAC and EUI-64 Basics in Packet Tracer

Рет қаралды 41,954

4 жыл бұрын

Using Packet Tracer, configure a router interface with global unicast and link-local IPv6 addresses and then observe the ICMPv6 router solicitation and router advertisements at work as the PC auto configures its IPv6 address using SLAAC and EUI-64

Пікірлер: 20

@Rdc_gd 6 ай бұрын

After learning the concept, this was a great straight-forward explanation

@sagul-sagul6046 4 жыл бұрын

For young network professionals out there, understand the concepts. These concepts will still be applied in non-cisco devices.

@chili5238 Ай бұрын

I love your videos man. My respect.

@juanmartinayonacarrera2190 4 жыл бұрын

Thank you for videos. Hi from Lima Perú.

@nuclearcatapult 4 жыл бұрын

I think your playlist *Cisco CCNA 1 - Introduction to Networking* is out of order because this is the first video I get.

@Asim-GiLL 4 жыл бұрын

Right .............

@johnmcneill1998 4 жыл бұрын

Anyone figure out an order to watch these in?

@gaatutube 4 жыл бұрын

Same here ... Got thrown right into IPv6 terminology ... most of which I don't understand right now. Wish some numbering prefix was added to the titles of these videos if they can't be rearranged.

@MRSheikhian 4 жыл бұрын

you are a very good teacher.

@MGChannel910 4 жыл бұрын

Good Tutorial, i'm from Indonesia,thx for tutor,

@uzairkhan2101 2 жыл бұрын

Thnxxx i have had an issue regarding this and this video fix that for me

@bish0p2004 3 жыл бұрын

Thank you for this.

@mohamedshameem8081 4 жыл бұрын

Please do vedios for ccna-security,I LOVER your vedios it will very easy to understand.I want to learn CCNA-SECURITY and am waiting for and good reply.😃😃

@MRSheikhian 4 жыл бұрын

thanks a lot my friend .

@Eriksi 4 жыл бұрын

Hello Dan, I'm at CCNA R&S at the Scaling Networks module. I'm at chapter 3: STP, but it is really complicated. I understand switch sends BPDU frame with BID: - Bridge priority - Extended System ID - MAC addresss Bridge priority is 4 bits and extended system id 12 bits. I still don't understand why it increments from 0 - 4096 - 8192 etc.. ? 12 bits = 4096 but how does it multiply to 8192 it would need a extended system id of 13 bits? (2^13)

@emiliakulik1102 4 жыл бұрын

Isn't it because You can have 4096 VLANs (including extended) and You can set every instance of STP its own priority?

@brianconner1212 3 жыл бұрын

the bridge priority as you mentioned isnt 4bits by itself , it is 4bits(bridge priority) + 12bits(system id extension) = 16bits(BID) Notice that you dont see the bridge priority individually, rather a decimal number that can be denoted by 2^16 number.