For ultra-nerdy car types here's my record of rebuilding a rear hub on an e-type Jaguar. More info at www.xketype.com . There's 2 jobs that require care; the wheel bearing end float and the fulcrum shaft pre-load.
Пікірлер: 15
@arthur192016 жыл бұрын
excellent production!!
@Rojao16 жыл бұрын
Nice job !
@ctc77965o13 жыл бұрын
@padge46 This is they one job where you need to borrow a press. I suggest you take the assembly to a local workshop and ask for their help to press-out the shaft (originally loctited-in) and then remove that inner ace with a bearing separator on the same press. Take care of the flimsy water thrower just behind that inner race. I could not get that shaft out with a puller on my etype...but earlier on an XJS I had one come apart with n force needed....
@orlandotaxattorney8 жыл бұрын
This video is very helpful.
@bartholomewchuzzlewit43562 жыл бұрын
Why not heat the outer bearing in oil so it just drops on?
@sweetd6912 жыл бұрын
Hi , I like this one.. It what i needed but do you have the same for a 1989 jaguar xj6 .My right side wheel hub rebuilding it different form this one you have.. I like to know how to put all the part back together.. and all the part i need .to put back.. Thank you..
@jeffreyprice7735 жыл бұрын
You should check the end float dry, no grease. No need to use a drive shaft yoke to tighten on, there is a tool for knocking the inner bearing in which has a shoulder stop on it of 0.150" you then fit a dti gauge on the tool then lift up the hub and take the dti gauge reading, then add the clearence you need to the reading, 0.003" to 0.005" endfloat. Then grease it. R.T.F.M Cheers from uk. What torque setting are you using, 100psi.
@ctc77965o13 жыл бұрын
I think you are talking about Jaguar Part No C15232 You should be able to get one from Barrats or XKSunltd
@keyboyrecords13 жыл бұрын
At 3:05 Did you say "collar"? I can't find this part anywhere. Mine burned up along with the inner bearing and now I have to grind the melted metal off the hub! Can you please tell me where I can find that last metal piece you put on because it does not come with the bearing kits and there are no 80's XJS's in the junkyard near me. Nice Video it has helped me alot and now Im stuck : (
@trulysick868 жыл бұрын
whats the bearings inside the hub where it mounts to the arm called? i need these as mine has play in it
@grahamprentice7 жыл бұрын
I am now rebuilding my IRS and as I am now doing the hub bearings I hoped to see a video showing the outer oil seal as I cant find which direction is the inside or outside? any pictures or videos would be appreciated.
@ctc77965o7 жыл бұрын
The protruding lip goes inside...thats the pressure side
@arthur19208 жыл бұрын
Question: I am into this now. How the heck did you get the old races out of the outer fulcrum hub? I can't find anything I can stick down there to hammer the grooves and move the race. The attachments on my slide hammer are too big to fit in and/or grab the race inside the tiny little 1/4 inch grooves
@wojtekpawlowski49516 жыл бұрын
arthur1920 hi, did you get these bearing tracks out? How?