There is. It’s step flashing. It is Black

Thank you Thad.

Did you see how steep that roof is

Hardy board unless it’s prepped properly inside out and edges. It’s definitely not going to be good for that area. I would say if you painted all sides with oil base paint two coats, you wouldn’t have that problem.

@@Drewsroofingandhomerepair I thought in the Hardie manual it says it shouldn't be in standing water, or 4 ft of snow. It does recommend to paint cut edges with their special Hardie paint but not where the bottom will be in snow all winter and to use oil base paints. Plus does that mean repainting is required in a few years?

3/4 inch is fine

We didn’t have to use the level we went by the old lines on the roof yeah. We put it up the exact same way it came back no level need it if you look on the wall you’ll see all the lines that’s all we had to go buy

I agree 100 percent. We painted with oil paint

We are pre-drilling the hardy board and that is where we nail it with hardy board siding nails 9:43

We nail them into the wall studs pre-drill first so we don’t crack the hardy board

Code here calls for it

Your the man soul scrapper. What do you think of my roofing gig?

Dang good work. I'm Da man huh? Not bad for a chick 😂😂😂😂

Yes amazing for a chick good work keep it up