Рет қаралды 126,402
This is the third Generator that Stanley donated to the channel. A friend of Stanley's picked this Generac 5500XL up from the dump. He fueled it up, pulled the cord and it started and made power! Things were looking good until the generator was pressure washed. It hasn't worked since. The generator was later given to Stanley. Stanley replaced the PCB (power control board) and reset the governor calibration, but has not tried to start the engine after the calibration. He was unsure of the adjustment he made on the governor and did not want to cause damage to the engine. This generator has now been discarded or given away by 3 different people. Lets get this poor generator fixed.
I use Harbor Freight Super Heavy Duty Degreaser in my ultrasonic cleaner.
Generator Model: 09778-3
Engine Model: GN360
Governor Spring: G073100
Kill A Watt: amzn.to/3I26bhR
Test Tank: amzn.to/3NsWppV
Handle Kit: amzn.to/3QYRkJ2
Visit My Amazon Store:
www.amazon.com...
If you want to donate to the channel, you can use the KZfaq "Super Thanks" feature.
5500 XL, Anti Lash Spring, Anti Surge Spring, Carburetor Clean, Carburetor, Droop, Engine Racing, Fixed, Fuel Tank Repair, Generac 5500XL, Generac, Generator, Governor Calibration, Governor Droop, Governor Reset, Governor Sensitivity, Governor Spring, Governor, Handle Install, High RPM, How To, How-To, PCB, Petrified Fuel Line, Small Engine, Tank Bushing, Tank Leaking, Troubleshooting, Ultrasonic Cleaner