No problem bro, I appreciate the support

Ezequiel Reyes why are they so expensive ?

@@reinaldonavarro3800 The price has actually gone down quite a lot in recent years. Back in 2013-14 a set used to run for $800 or more for the lights alone with no bulbs compared to around $300 today. The reason why it's still expensive is because they come from a car that was never sold in the USA, so they're still pretty rare and much harder for sellers to source them.

@@NoPointOfThis123 nice work man they look amazing. Were did you get the headlights?

@@MiguelLopez-wi5nm I got them from ebay

Facts I wanna do all that stuff pretty soon but I gotta save some money first lmao. But it won't be too long until I'm full Inspire

I used 16 gauge wire at the time, and I'm pretty sure you can use 7443 as long as you can make the socket fit inside the housing. I used a dremel on my old 9005 LED low beam bulbs so they would fit in the 9006 socket for the Inspire high beam.

Yes, they are OEM JDM. I got the headlights from ebay and the bulbs from Amazon Japan. I have a link to a google doc in the description, but there's an adapter cable for $10 that allows you to plug the HID ballasts into the stock connector.

I was actually thinking about that before I just need to figure out how to wire them in

These are usually for sale on ebay if you just look up "UC1 headlights"

I linked a google doc in the description with everything you'll need

@@NoPointOfThis123 oh wow ! You're the best thanks

I got them on eBay but you can also find them on some Japanese auction websites like Jauce

@@MrCutlash I didn't have any issues with them when I had this car. I just had to aim the left side low enough that it wouldn't blind oncoming drivers. On country roads with no street lights oncoming traffic would flash back at me occasionally but in cities it's fine.

Leppein makes a good Switchback LED for these cars, I have them in mine and they work great. Look that brand up on Amazon!

@@ericcraighead9158you still have it?

Also, D2S is projector housing, D2R is reflector housing..... not all are cross-capable

Allegedly D2C = D2R + D2S Which would mean D2C works with both because its got both notches

It would still work, I'm pretty sure you can pull the DRL fuse and it will make them function only as high beams

Mine work you have to make or buy a adapter harness a seller on eBay sells them for $150 a piece Mine still work after two years

They call it a city light or position light but yeah it's just a drl that can be turned on and off on the accord harness

Yes, this car was 03 EX.

They have some on ebay if you look up UC1 harness

I'm not sure if they make LED D2S, because D2S bulbs are originally HID. But they are very bright anyways as long as you buy a good brand.

They only turn on when the headlights are on, either in low beam or just parking light mode. If you turn them off they'll be off completely

There's someone on ebay who custom makes them if you search "UC1 Harness"

These were just from ebay, if you look up "UC1 Headlights"

Yes the low beams in these are D2S which are only available as HID since they use a ballast to power the bulbs. I used to have LED in my stock headlights as well, but these are brighter plus they don't blind oncoming traffic

Yes they only come on with the parking and low beams. You can probably look up how to disable the high beam DRL if you don't want it or do some other wiring setup

Yeah the wiring harness just splits the stock turn signal into 2 separate bulbs

In the description you will see a document with all the parts

Yes the top part lights up with the high beams, I put LED bulbs into them and they were super bright

You need an LED flasher relay or use resistors with the turn signals. You can get the flasher relay here: www.diodedynamics.com/lm526-led-turn-signal-flasher.html And this is how to install it: m.kzfaq.info/get/bejne/gt1-iKWamJPVmWQ.html

@@NoPointOfThis123 nice video man. How much were those headlights?

@@MiguelLopez-wi5nm Around $300 for the headlight assemblies and $150 more for the bulbs, wiring, etc

Nice man. Im on the headlights. Keep us update with your videos man. Thanks.

Headlights you can search "UC1 Headlights" on ebay and the radio is in the link on my radio video

The turn signals are 7440. 7443 is only for the brake lights, which look like nearly the same bulb but they won't actually work in the turn signals

The bulbs in the description will work as turn signals for the rear, for stock headlights you need 9006 LED low beam and 9005 for high beam. The other bulbs will only work on Inspire headlights

Amazon Japan but they should have them on HID Concept

@@NoPointOfThis123 thanks a lot for your reply appreciate it a lot

Yes it does fit on the coupe

They're in the description in the Google doc. You can change the language to English using the icon of a Japanese flag in the side menu of the website on a phone or at the top of the page on a browser

You can find the part numbers on this diagram, and look them up and see where they are for sale. I would recommend a website called "Amayama" to get brand new OEM JDM parts. LINK BELOW jp-carparts.com/honda/partlist.php?maker=honda&type=INSPIRE&cartype=12258&fig=B&fig1=800

If you have an 06-07 Accord that's just how they are from factory. You can look up if there's a way to disable the factory DRL or just drive with the low beams on instead

@@NoPointOfThis123 I appreciate you man theyre hooked up I love em

I put an LED flasher relay from Diode Dynamics instead. That way it doesn't hyper flash and the LED's don't use as much power as they would with resistors.

I just did a basic drawing but there's not really a full diagram. The plug for the DRL and Turn Signal has 3 wires on the stock harness. The middle wire is ground, and the outer 2 are each power with 1 being for one bulb and 1 for the other. You just need to split the harness, run the ground wire to both, and each respective power to the correct bulb (can check which one flashes turn signal using a multimeter.) The low beams can be done using a $10 amazon harness in the Google doc.

Yeah I was going to but my grille never came in lmao. And now it's almost winter so it's too cold to do anything but in spring hopefully I can install it

😂 that’s crazy. Oh also are your rims from the 07 accord? I used 08 tsx rims but I’m kinda feeling your look a bit more.

@@ToniJ95 Mine wheels are 8th gen V6 coupe

You can find the bulbs in the description, for the headlight housings I got them off ebay

It should be the same steps as this video to get the headlights and bumper off. Bumper has a few extra bolts on the bottom as well. If it has both a sunroof and volume controls on the steering wheel it's an EX.

@@NoPointOfThis123 Thank you and yes it does so it is an Ex lol. But any idea where I can buy the bumper?

@@samidpersia9832 I would check a junkyard at first, sometimes you can find them pretty cheap and already paint matched. If not, ebay would likely have them as well

@@NoPointOfThis123 lol junkyard fr?? but yeah ebay sounds good

@@samidpersia9832 It depends on what's near you, I've seen tons of junkyard Accords that have been rear ended so the front bumpers are still perfect. It would be cheaper that was but ebay is better for convenience factor

I installed an LED turn signal relay which goes above the drivers footwell. Resistors make LEDs use as much power as a stock bulb, but with the relay they don't hyperflash and still save battery power. You can find this by looking up "LM526 LED Flasher Relay"

@@NoPointOfThis123 awesome thanks man. 🙏 i just got my headlights. Now getting the bulbs.. for the d2s. What webpage i can find them? Thanks ..

@@MiguelLopez-wi5nm Those are in the description, I got them off Amazon Japan. You can click on the Japanese flag icon at the top of the website or in the side menu to change the language to English. It had free shipping at the time I ordered them and I believe they still do.

Great .. thanks mann. 🙏💯

Hey man . Note..I have a 06 accord. And it has daytimerunning light but its on the high beam. Its going to look different from yours..you suggest unplug the highbean since we dont use it?

Up at the top there's an icon that looks like a globe that translates it to English. On phones the icon will be at the very very bottom. If you want you can DM me @natecolena on IG if you can't find it

Also from ebay if you type in "CL7 Hazard Switch" for 03-05 cars and "CL9 Hazard Switch" for 06-07. The connectors are different in both so make sure you get the right one.

The ballasts were replacements for a 2008 Acura MDX (made by Matsushita, same as stock Inspire.) And the headlight brackets were just the stock ones off the car

At 13:03 you can see the adjustment screws in the picture, it's the circular gold ones. There are 2 adjustment screw on the outer parts of the headlights that can be adjusted the same as the low beam.

Okay so i have the stock headlights on my accord not the inspire ones.. i havent been able to even find the screw to adjust the low beams. 🤦‍♂️

@@ashishjangir8885 I found this video about how to do it, but I believe the high beams can't be adjusted on the stock headlights since they are next to the low beam instead of above it like on the Inspires. kzfaq.info/get/bejne/bql1gtalktfRk6c.html

Yes all 03-07

@@NoPointOfThis123 thank you

I got them from ebay by just searching "Inspire UC1 headlights"

@@NoPointOfThis123 im only getting the headlights; maybe i was specific web site to the lights package you gotten from Japan light bulbs

@@stevem3384 Yeah in the description you'll see where I got the bulbs from but the headlights alone were ebay

I don't remember the seller I just got the ones that looked like they were in the best condition

Check the bulbs and if that doesn't fix it make sure the wires are still good

I just looked up "Inspire UC1 Headlights" on ebay, there's usually several pairs for sale no matter when you look due to how popular they are

@@NoPointOfThis123 gosh they are expensive but i cant find a similar look any other way. Thanks for the assist!

Those might be plug and play but I'm not completely sure

@@NoPointOfThis123 someone said you have to wire the led light bar to the parking lights. Not sure how to do that

@@braydonmotivation141Ok in that case it should essentially be the same thing, you just need to tap into the turn signal plug and find which power wire is running constantly instead of blinking

@@NoPointOfThis123 so that wire is for the running lights. That connects to the led?

@@braydonmotivation141 Yes, the stock harness for the turn signals has 3 wires: 1 ground in the middle and 2 power on each sides. One of the power wires will stay on with the headlights (parking light wire) and the other wire will only flash with the turn signals.

For the high beams I've now replaced mine with 9005 LED. The low beam uses HID and only D2S bulbs will fit

NoPointOfThis123 so wiring isn’t required necessarily?

@@SteezeThePlug You need the wires for the low beam, and another to split the stock turn signal bulb into 2 bulbs (city/DRL and turn). High beam you don't need wiring.

It just depends on how much you want to spend. I forget what seller I got mine from, I just clicked whichever came up first at the time. Usually it doesn't make a difference as long as the condition looks good.

@@NoPointOfThis123 can u recommend a few sites to look at? Thanks for the help.

@@just_jun2 Ebay is usually cheapest and has good variety if you just search "Inspire UC1 Headlights"

There's still some for sale on ebay for $120, I just made the exact same things so I could learn how www.ebay.com/itm/2003-07-Honda-Accord-to-UC1-JDM-Inspire-OEM-HID-headlight-adapter-harness-UC3-/333222438337?oid=333174105672

Ebay if you look up "Inspire UC1 Headlights"

They are on ebay sometimes if you search "UC1 Headlights." They come from the Honda Inspire UC1 which was a car only sold in Japan

The Inspire doesn't have sidemarkers either, only the Accord CM5 in malaysia and other southeast Asian countries does. But yeah Honda sure loves to give USA the most basic models

That's just the terminology used on lots of Japanese-spec cars. It's the same as a parking light, corner light, DRL

@@NoPointOfThis123 city rhymes with s-ttty

@@NoPointOfThis123 lol