Jeep windshield bolt extraction/ removal.

No video

Jeep windshield bolt extraction/ removal.

Рет қаралды 8,283

Күн бұрын

This is a How to video to remove Jeep CJ, YJ, TJ, JK, JKU, JL windshield frame bolts after the torque strips out the bolt head.
This is a simple how to video on how to remove the windshield bolts with a drill bit and easy outs/ extraction tools. This does not always work and sometimes you still have to drill out and tap the 5/16" bolt or bolts.
The link below are link or links to tools used in this video.
www.amazon.com...

Пікірлер: 16

@Satchmojones 2 жыл бұрын

never really thought of the leverage thing, next time i use an easy out imma grab a tap handle...same principle as taps and ive used em a thousand times can't believe i didnt think of it till i watched you, thanks man preciate it.

@chadfox4097 2 жыл бұрын

If you have room to use then they are great. There are a lot of locations there is no room to use one.

@markking6136 2 жыл бұрын

Thank you Chad

@MyNeighborsaJackAss 7 ай бұрын

Awesome sauce! Thanks. I just stripped one really good and starting to on the other side. Someone else was advising to use a propane tank but I’m concerned about the paint. This I’m going to try right now. I was trying my extractor bits like yours but the technique was slightly different. 👍

@johndoe43 Жыл бұрын

Good tips. I had some that were badly ate up. They ruined my lisle made in USA torx bit. I went to auto zone and it was made in Taiwan. It survived the worst ones and did the job with no damage to the tool. Surprised me. I'm always USA.

@autorobb Жыл бұрын

thanks chad great video..

@campcrafter4613 11 ай бұрын

Thank you!

@bargainfisherman7014 6 ай бұрын

Good video, for me the welded nuts on the back side broke😂

@trev119 Жыл бұрын

Thanks for the tips and tricks itll help a ton im sure. You seem like a wise man with experience.

@chadfox4097 Жыл бұрын

I’ve been rebuilding vehicles since the late 80s.

@Red_right_hand1 Жыл бұрын

Thank you sir you saved my day

@chadfox4097 Жыл бұрын

Your welcome

@felishiadarling 7 ай бұрын

I’m going crazy. I’ve tried this too and the easy out is stripping thru too. I think I’m going to have to use my drummel and cut a line for a flat head. 😵‍💫🤬

@chadfox4097 7 ай бұрын

Drilling the head off. Then make sure you verify the drill was centered in the bolt. Then drill a hole in the center and see if that will relive the pressure enough to easy out the bolt. I’ve had some that were so bad I’d have to make a new plate.