In this episode once again I try new technique, which is applying paint on the inside side of the laminating film. It turned out very good, the film can be use as usual, by heating it with covering iron to activate the glue. Thank you Aero Ergo for the tips. Also in this episode I announce new feature from KZfaq which is a membership. It's just a way for you to support me so I can make more model with EDF (which is expensive). A member can download additional decal files. Beside that, in this episode I show you how to mount the wing to fuselage, make the engine cowls, cover the plane and applying decal.
SUBSCRIBE and Like to support this channel
#dc3 #rcplane #buildvideo
You can download the plans on the link below :
A4 Plans : paper-replika....
A0 Plans : paper-replika....
A3 Decal : paper-replika....
Build instructions :
paper-replika....
DONATE via Paypal : Juliusperdana@yahoo.co.id
Aero Ergo channel : / @aeroergo
Specs :
1. Wingspan 2200mm / 87 inches
2. Flying weight : -
3. Wing loading : -
4. Wing cube loading : -
5. Wing Area : 25.2 dm2 / 391 sq.in
6. CG : -
Electronics
- 2X Turnigy 2830 1000kv brushless motor
- ESC 40A
- Battery Lipo 3S 2200mah - Li-ion 3S 3300 mah
- 4 plastic gear 9 gram servos
- 5 metal gear 9 gram servos
- Propeller : 9x6x3
Materials :
1. 5mm & 10mm Depron/ Polyfoam
2. 3mm Plywood
4. 0.3mm Mica Plastic
5. hot glue + CA glue + UHU glue
6. packing tapes amzn.to/3ttYTMp
Tools :
1. Covering iron amzn.to/38YZyMh
2. Heat gun amzn.to/3A1cvkR
3. Hot glue gun amzn.to/38XyrkY