Jumper T-20S | The Most Stunning Radio in FPV

Рет қаралды 5,397

Күн бұрын

The T-Lite and T-18 are some of Jumper’s most popular radios, but what if you wanted something between the two. Jumper now has you covered with the T-20S, a Full-Sized radio, smaller than the T-18, but packs a powerful punch with a 1000mW transmitter, and RDC90 gimbals. This thing is a looker, and probably one of the most beautiful radio in the hobby right now. For more information, check out…www.jumper-b2b.com/t20s-p0116...
Buy The T20S Here: usa.banggood.com/custlink/vDv...
Buy The 4-in-One Module Here: usa.banggood.com/custlink/Gm3...
Buy 21700 Batteries Here: www.getfpv.com/molicel-p42a-2...
Buy the T-Lite Here(10%coupon): bit.ly/3bUXiec
Buy the T-Lite Here: amzn.to/3c0yUI1
Buy the Jumper T-Pro Here: amzn.to/3oAq9r6
ELRS Nano Module: bit.ly/32Rjod9
ELRS Micro Module: bit.ly/3ghlTIF
ELRS RX: bit.ly/3IWc6nD
Crossfire Nano Module: amzn.to/3gmic4k
Crossfire Retro Kit/Case: amzn.to/3ufHtFL
Crossfire Receivers: amzn.to/3rjtdK2
Buy Sony VTC5 Here: bit.ly/3t1YK4d
Buy Sony VTC5 Here: bit.ly/379JCsX
Buy Sony VTC6 4S Here: bit.ly/3pRg0qX
Buy 18650 Battery Charger: bit.ly/3vTB6sx
* All links are affiliated unless otherwise stated, and helps support the channel at no cost to you. Thanks
Join me on Instagram: / onemanunmanned
RELATED VIDEOS:
T-Lite V2 Review: • Jumper T-Lite V2 | Han...
T-Lite Differences V1 vs V2: • Jumper T-Lite Comparis...
Jumper T-Lite: • Jumper T-Lite Review |...
Jumper T-18 Review: • Literally The Best Ful...
Pavo Pico: • Pavo Pico - Mind Blowi...
Freewell ND Filters: • AMAZING Results From O...
DJI O3 Air Unit Review: • DJI O3 Air Unit - Shou...
Pavo25 HDZ: • PAVO25 1st Flight | So...
Pavo 30 Review: • BETAFPV Pavo30 | Setup...
DJI Goggles V2 1st Impressions: • Everything you NEED to...
DJI Goggles V2 Setup & Flight: • DJI Goggles V2 Setup &...
Bind DJI Goggle to O3 AU: • Binding DJI Goggles V2...
#t20S #JumperRC #elrs

Пікірлер: 49

@sullytrny 10 ай бұрын

I put RDC gimbles in a RadioKing T18S (5 in 1) two years ago, and its been flawless on HM24 PRO TX module and R9 elrs TX . ~1500 flights I ordered a 915 t20s Thanks

@OneManUnmanned 10 ай бұрын

RDC gimbals are not bad.. They were used in high-end radios of the past.

@JasonParham83 10 ай бұрын

My new favorite hobby reviewer

@OneManUnmanned 10 ай бұрын

Thanks Jason 🙏

@dakzer55 9 ай бұрын

Thanks for the review. You are the only person to try using the very slim 4-in-1 external module. If it doesn't work with Frsky D, then might be a deal breaker, as the Radiomaster Boxer is only a few dollars more for the CC2500 model.

@OneManUnmanned 8 ай бұрын

Thanks I appreciate that. yeah, I tried.

@Mr.Laidukas 10 ай бұрын

14:28 it is just how those old receivers work, you must keep the Tx and Rx at least 1meter apart or Rx radio frontend will saturate stop receiving signal. That new module might be more powerful and so it will saturate receiver easier. Just increase the distance.

@OneManUnmanned 10 ай бұрын

I did try a few times off camera at multiple distances.

@nategoodwin3329 10 ай бұрын

I ordered this with Hall effect gimbles and the 4 in 1 in 2.4 less than an hour ago. 😂😂😂 . I've been on the Jumper T16 pro since 2019. If I don't have to replace ribbon cables or switches, I'll be happy.

@OneManUnmanned 10 ай бұрын

Haha..The T-18 Pro fixed all those problems including adding a touchscreen. Yeah, I think you’ll be fine with the T20. Thanks!

@MrKillerHobbes 10 ай бұрын

the rdc sensors press up against the speaker connector on the pcb causing it to break. the switches up top are also awkwardly pressed up against each other and overtightning the swith rings can easily damage the switches. Plain bad design, jumper always doing this dumb shit@@OneManUnmanned

@S7E7V7E7N 6 ай бұрын

Do you still like it? Im torn between this and the boxer. ( Wish there was a gamepad style controller that matched those 2)

@OneManUnmanned 6 ай бұрын

I don’t own the Boxer, so I can’t comment on it, but most reviewers have very positive things to say about it. I myself like gamestyle radios as well. I don’t think you can go wrong with the Boxer, and it has a full size JR bay as well.

@kolten808 10 ай бұрын

Best review of the T20S 🍻😄 Someone needs to make a module w/ fan adapter if anyone is concerned about they little digits 🤣🤣 The telemetry issue is regular on my t lite and t pro, doesn’t bother me so long as I have a strong signal to transmit. 😄

@OneManUnmanned 10 ай бұрын

Haha, thanks..yeah, that would be a good way to keep the Heatsink cool. I’m sure someone will come up with it soon or later. Or you could wear silicone gloves while flying 😄

@S7E7V7E7N 6 ай бұрын

Jumper t20 Gemini heard you.

@choppergirl 9 ай бұрын

KababFPV says it has a sht1t0nne of problems with the Gimbals. That's good enough for me, I'll wait for V2. A man that takes a dreml to his radio on a reguar basis to fix things about it that annoy him is hardcore like me. Been there done that.

@OneManUnmanned 9 ай бұрын

That’s cool…Everyone has their specific needs. Maybe V2 will make a better impression. Thanks.

@wehttamak 8 ай бұрын

the issue that I have with Jumper is QUALITY!!!!!

@OneManUnmanned 8 ай бұрын

Understood

@fordboyzzzz 10 ай бұрын

my jumper t89sg plus hall sensors played up once - servo's on ailerons went super slow like a dead battery - I pulled it apart and cleaned and checked the plugs it's been fine since but for that reason I would get the rdc90. Question I see some planes can get the transmitter to talk eg: altitude, rpm, temp.. can this transmitter do that if get the right plane receiver? I'm old school lol.

@OneManUnmanned 10 ай бұрын

I don’t know for wings, but most receivers in FPV quads have the ability to send telemetry back to the radio. The radio can then make certain callouts based on the parameters or if there were limitations set.

@fordboyzzzz 10 ай бұрын

@@OneManUnmanned thank you. - can this transmitter talk back? If I upgrade I would like one that can. Cheers - all the way Frm N.Z

@joshgraystone8815 10 ай бұрын

I haven't seen a mode 1 model online. Would i have to open the radio and swap arlind the gimbals or cam i adjust a few screws to change tension/modes?

@OneManUnmanned 10 ай бұрын

Typically you just adjust the screws in the back to change from mode 2 to 1. I don't think it requires a swap of the gimbals.

@joshgraystone8815 10 ай бұрын

@OneManUnmanned thank goodness. Thank you for your reply! Love your content.

@athenovae 7 ай бұрын

How easy does the module antenna come off? :)

@OneManUnmanned 7 ай бұрын

It doesn’t come off easily. It fits on there pretty securely.

@technicalsupport6983 10 ай бұрын

How to connect this Jumper T20 radio with mobile to get telemetry data ? If not then how to connect external bluetooth device in it ...!!

@OneManUnmanned 10 ай бұрын

There is no Bluetooth module in the radio, and don’t know any (off the top of my head) that interacts with this radio.

@technicalsupport6983 10 ай бұрын

@@OneManUnmanned then this remort is useless

@OneManUnmanned 10 ай бұрын

I don’t think its useless because it doesn’t broadcast info over Bluetooth. Is there many FPV radios on the market that can do that? Maybe the information can be shared via WiFi from the internal ELRS module…I don’t know.

@technicalsupport6983 10 ай бұрын

@@OneManUnmanned then please find a solution .....I want telemetry data in my mobile for long range ..........

@Maceyee1 10 ай бұрын

After you bind you have to restart the radio. Your other radios are not using the new bind but the last one

@OneManUnmanned 9 ай бұрын

I’ve tried that as well. Thanks

@howhighdrones777 10 ай бұрын

🏆🏆🏆

@OneManUnmanned 10 ай бұрын

Thanks Bro!

@howhighdrones777 10 ай бұрын

Keep up the great work 👍🏽

@LehtusBphree2flyFPV 10 ай бұрын

ELRS for the win

@OneManUnmanned 10 ай бұрын

Haha...True statement!

@Mr.Laidukas 10 ай бұрын

I personally do not like esthetics how those two potentiometer are implemented. They maybe are convenient and ergonomically and fact that they are mandatory but not bountiful :)

@OneManUnmanned 10 ай бұрын

They are not bad, but we should have the option to choose.

@aaronvandegrift6478 10 ай бұрын

I kinda like how it looks but I agree about the UI being all clumped together on one spot, the screen also looks super small too. There are also no dedicated trim switches which would be a little annoying for fixed wing stuff.

@aaronvandegrift6478 10 ай бұрын

Nvm I thought those bottoms were screws… nah all my criticisms are invalid

@OneManUnmanned 10 ай бұрын

Yeah, it has trims.