Amazing work! But I wonder about the big crack in the middle of the beam at 6:55. Is that going to cause trouble?
@vencent83294 жыл бұрын
D Jenney depend on the section of the frame
@colinbateman82334 жыл бұрын
I’m curious to know why you spray water on the joints but admire your skills and work
@dp13812 жыл бұрын
It softens the wood to make paring end grain easier
@mehdikoschin5651 Жыл бұрын
👍
@vanderleymoreirademelo33983 жыл бұрын
SÃO PAULO - BRASIL 08/2020
@ponndelion47785 жыл бұрын
霧吹き ナイス いい 濡らしたほうが いいな 賢い さすがや 大工
@lorenzonainer63284 жыл бұрын
wath kind of wood? Cedar?
@moltedo374 жыл бұрын
It takes years to just learn how to sharpen and set planes first. Than you can learn this, It looks wonderful but life is to short. But I get a lot of enjoyment just looking how amazing they are.
@morgorth32422 жыл бұрын
its not that hard i sharpen and chissels and planes by hand japanese way
@pretendofriendo78894 жыл бұрын
Can someone tell me that name of that drill that makes square holes please? It is a marvelous device!
@dp13812 жыл бұрын
Hollow chisel mortiser
@edwinroy_paucara_otazusiku77214 жыл бұрын
sugoi
@k.m.colwelljr.1365 жыл бұрын
Was that water that you sprayed on your chisel cuts? If so, or if some other liquid, what is the purpose of its use? Thank you in advance for your response 🙏🏼
@pyrocentury5 жыл бұрын
My guess would be to prevent blowout in the end grain. I've seen others using this technique before.
@T3hJones4 жыл бұрын
In soft fast grown wood it makes end grain cutting much easier.