These were some of the things I had to research and figure out through building mine, and figured I'd compile them all into a video, hope it helps you! Will
Пікірлер: 13
@emacflores79147 ай бұрын
Nice this is what i got installed on my nissan 720 mini truck 🔥🔥🔥🔥
@jones3 ай бұрын
🔥🔥🔥🔥
@jeepingneatus4 ай бұрын
Thanks for sharing. This was very helpful.
@cbeig4 ай бұрын
Glad to hear it! More 240 content coming.
@frias22878 ай бұрын
Nice🔥🔥
@cbeig8 ай бұрын
Thanks a lot! Real excited to finally get on the road
@isaactrujillo26946 ай бұрын
For the coil sub harness, did you wire the following into the MSPNP2, Spark output A (pin 17) from the MS ECU to cyl 1 and cyl 4 coil and B (pin 16) to cyl 2 and 3 coil? For the wiring of 1-4 coils did you crimp or solder the wires together? Thank you.
@cbeig6 ай бұрын
This is the sub harness I used: www.wiringspecialties.com/honda-k-series-smart-coil-conversion-harness-for-s13-ka24de/ I am on a Link ECU, but all of the flying leads are labeled so you can match it all up. I use heat shrink terminals from Amazon for my soldering, so no crimping. These are them: www.amazon.com/dp/B0CD77KTB6?ref=ppx_pop_mob_ap_share
@isaactrujillo26946 ай бұрын
@@cbeig Thank you. That’s the harness that I currently have, should be straight forward from here. Where did you get your 12v for the coils?
@javiguzman69048 ай бұрын
What ignition coils are you using?
@javiguzman69048 ай бұрын
Nevermind lol I rewatched it😅
@thadarkone508713 күн бұрын
does the Coil On Plug Conversion work on the stock ecu ?