Thanks for your comment

Thank you for your comments. I appreciate it. Glad it helped you. Regards

I am so glad you liked it. Regards.

Hola Manuel. Gracias por tu comentario. Fuí a Madrid en el 2001 y es muy bonito. Mi apellido es Galicia y me gustaría un día ir a Galicia a conocer. Saludos

@@FranciscoGalicia hola Paco. Te animo a que lo hagas, es una región maravillosa, merece la pena visitarla por al menos una semana, no te defraudará 👌

@@manuelmartintorvisco6226 lo haré. Un abrazo.

Thanks so much for your comment. I appreciate it.

mine as well, I put a lot effort on her and brought her back to life

I am so happy that it helped you. That was my main goal. Cheers.

@@FranciscoGalicia, I know you didn't do a final video, but is this repair made the starter clutch work better? I hope so:-)

@@Tosalangre yes. It does. I think my starter motor is a bit weak as it turns slow. Thank you

Thank you. I am glad you liked it.

Thanks for the comment. I really appreciate your message

Thank you for watching

So happy that my video was helpful. Enjoy.

Hello. Thanks for your comment. I am not confident of if is the same or not. But you can compare the 1978 kz650 components used at partzilla.com and see if is the same number. I heard there are a lot of common components between those bikes. Z wyrazami szacinku

Haha. Sometimes yes. Is in my garage so I feel like home. Thanks for watching

By the way. Sometimes I just start it with the kicker as I like that.

Que gusto que te haya gustado. Un abrazo

thanks for your comment. Once in a while I have an issue starting it. I think is because the electric motor is not strong or fast enough. So first start with kick and when is warm it start good with the starter. thank you

Thank you. The starter was spinning. Like free rotation without moving the motor. Also the noise was weird. Happy to help.

here is the sound of my starter clutch going bad: kzfaq.info/get/bejne/mLGRqaRlt7OmlWQ.html

Thanks for your comment. When the crank spins it can be as the rollers are spinning because of the weak springs. I learned after that that you can stretch a bit the springs in order to avoid the mechanisms to spin. Where the barrels touch may be good to have it rough so they don't spin. Hope this helps

Don't rough up any surfaces (as these are case hardened if you are able to rough them up you will have wrecked them) sprag clutches (or one way bearings or starter clutches) work on a lock up principle that only works in one direction , weak springs or flats on the rollers or both are what causes a slip (rattle) then you push the starter button, replacing these parts normally sorts out the problem , ps never try and start your bike with a low battery as this can cause early failure of starter clutches.

here is why you need to change your starter clutch: kzfaq.info/get/bejne/mLGRqaRlt7OmlWQ.html

Hola. No entiendo. Inglés o español?

@@FranciscoGalicia Hola tengo la misma moto con un problema cuando el motor esta caliente se enciende la luz del aceite, le cambie el filtro de aceite y el sensor de presion pero el problema persiste gracias

@@rosarioboccia7268 hola. Gracias por tu mensaje. Lo que pienso es lo siguiente: bomba de aceite, falta de aceite (se revisa fácil) , que el sensor de aceite no funcione correctamente o este mal conectado. Creo más en que el sensor no funcione bien y falle con la temperatura. Espero sirva la información. Saludos