same mate I have both 20lbs haswing and one of these petrol motors

@@michealthomas3042 So, whats your verdict? Which one do you use more and why? Would you mind me asking?

@@michealthomas3042 what do you prefer when saltwater fishing?

Loved the engine rig but afaid im not a big fan of the petrol motor (the noise and fumes) but like the rig. I have a 65lb heavy duty electric and about to add a rig. Great video buddy.

hi , i got the same engine same mount but seems to be a bit unstable

The motor can get rained on or washed with fresh water just don’t wash it when the engines hot

Always haters. Go stick your head next to a whipper Snipper if you need to hear one haha

Done Subscribe

But not practical I meant

It steers like any outboard via tiller arm. It swivels up for paddling.

Richard Aparicio wow u are dumb if a boat motor doesnt these dont

drrr how come a 200 hp mercury dont but a 1.5 hp can hahaha not a Fishman I guess 🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣

weed wackers were noisy TWO strokes . This OMC 1.5 hp is a FOUR stoke. I know cos I forgot to add oil to sump. Ran for a year ok without oil. Still going but smokes. Reliable.

I wouldnt think you have to with this, but I've been to lakes and parks where they specify no gas motors on small vessels at all. Electric only.

Look for an idle adjustment screw on the carburetor too back out a little bit maybe? I don't know if it would have one since its such a small engine.

Could be an air leak too have a look around the carb gaskets

Kayak leans a little. Moving slightly to opposite side in seat fixes that.

Lo ideal es agregar al kayak flotadores en ambos lados para darle estabilidad y seguridad.

lmao!!!

You can put one leg out on the other side of the motor and it will counterbalance. :P

Don't worry about that sweetie, men can figure it out.

Ismael I bought mine some 3 yrs ago from MIGHTY BOY Ian Miller 165 Thorp st Motueka.Nz 7120 email: mightyboynz@gmail.com. web: www.mightyboy.co.nz I took 150 mm out of the leg so engine sat low and is behind me. Control arm is in line with my waist. Cut leg needed proper welding to reattach lower drive spline. As I was used to small 4 stroke engines ,I forgot to add oil to the crankcase. Now it needs oil rings and perhaps more after It gets pulled down. It was less than $500. Can`t remember. It`s OMC (american motor company) made in China. Ian Miller is first rate to deal with. No need for the safety cord. The throttle is spring return by loosing the screw.

He did state he hadn't done a range test. It also runs on petrol, not gas.

It's been 5yrs you would figure he did some kinda test. I'm American so petrol is gas to us.

@@addictedjr3553 And school shootings are a national sport, doesn't make it right. Petrol is a liquid, not gas.

@@addictedjr3553 about an hour mate

Ernesto Valdes es solo una herramienta de jardineria modificada

Hi, just purchased one took out once, very big lean, also I noted the hi and low throttle, mine just appeared to go the same speed, it didn’t change when I went from low to high, does it do that until it’s warmed up properly. It just shot off when I started the engine, the only way I could control was through the primer.

I have one used on an inflatable, inflatables have more drag in the water, and it will run around 5 to 6 miles per hour at full throttle.

@jack bone Jack, the tank is only about a pint but it will run at full speed for about an hour. The motor is very light and depending on the boat weight it can push the craft at a good pace.

No

Because this motor is SUUUUPER loud. Like a weed eater at full throttle right next to your head loud

Lol it is wee eater

Electric

Kev, Bought mine from mightyboynz@gmail.com

You have the ability to adjust both the depth as well as the tilt. one issue I had with mine was that you may need to get a 2 by 4 wood block as the transom clamp is designed for a thick transom. At least that was my experience. My inflatable had a 1 inch transom and I needed a small wood block to accommodate the expected thickness..

UP and down. Tilt too.

Andrew Biasetti eBay

mightyboynz@gmail.com

Spiros Kardianos I’m not sure of its top speed, it’s two stroke so probably a bit more mainstence and it’s a cheaper quality engine, better to get a Honda engine

About 18kilo

mightyboynz@gmail.com

matthew lee got a better idea?

omg did you not watch the start 😪

They are a Honda GX35 clone. Great motor.

OMC ( outboard motor corp )

You can get the motor on Amazon for a few hundred $s. If you purchase one, just make sure that you put lube in the lower unit. Many people have not and have had bad results because of such. The motor is very easy to start up.

mightyboynz@gmail.com

You can probably mow the lawn with the propeller!

It's about a necessity, not a speed. Saves you paddling on a hot day. 10-12 km/hour is all you can get out of a setup like this. Riding faster and without outriggers will be a suicide. On my canoe with 2.5 HP motor (transom mounted) I can't open throttle more than 1/3, the bow is riding too high, with me seated midship, long tiller extension.

you need a better kayak. Flat bottom so it plans on the water would make a very big differnece. Nice to see thouh. Hate all the electric shit and that engine was small enough to carry. Where did you get it from? Shorten the rigg so the propeller is about 2 inches under the kayakbottom and put the engine at the back aned of the kayak. Then you could put the gas to the feet and steer with your paddle or a rodder.

Kuk Huve except, how the hell do you start and stop it when its way down the back?

where did you get the mount?

It's at his shoulders. A bit high to raise the hand to pull the rope while sitting, but doable. I am more concerned about stability with 12kg off the side, and motor head that high.

Does he sound American dipshit?

lol @@Creptex

na dont need that crap if you know what your doing

Scooter Build and tricks 12kg

Weigh. You're welcome.

Scooter Build and tricks Fucking idiot ever held a trimmer?

Weigh