This video shows how to recalibrate a console on a Keiser M3 indoor cycle without a calibration tool.
Пікірлер: 9
@snowliu79683 жыл бұрын
Thanks for the video.very helpful
@mikeruggia73703 жыл бұрын
Happy to help.
@realest_shirts11 ай бұрын
My screen just went blank. Assumed it was the battery dying. No? Batteries last forever?
@YA-hf5tk3 жыл бұрын
What if doesnt say calibrated
@mikeruggia73703 жыл бұрын
Hello. Are you getting an error message? I would try again. If you're handle bar position is slightly off of you go through the process too fast or slow, it may not work
@YA-hf5tk3 жыл бұрын
@@mikeruggia7370 no i didnt get any error message...the screen had the numbers. But no calibrated or error message
@mikeruggia73703 жыл бұрын
@@YA-hf5tk it sounds like you may have a defective cable of read board/sensor which is located in the brake assembly. I'm assuming you have a known good console. Be sure that wire is seated properly at the lower read switch in the brake hub area. It looks like a telephone cable connection.
@YA-hf5tk3 жыл бұрын
@@mikeruggia7370 i will tackle it today again and see what happens. Ill update you.
@rickc2222 Жыл бұрын
@@YA-hf5tk same here, with known working display... board is pn 555012 assy 550912 build 3.02. this method did not work for me either. does not display calib or any errors...