Thanks, Red Fox. This video was very helpful for my first time removing my snow thrower. 👍

Thos video has helped me so much you have no idea. Thank you again.

For the "K-Connect" snow blower mount, remove both while still connected. You only need to remove the two mount pins and hydraulic lines to place on "T" shaped dolly. Two non turning wheels under the blower and one rotating wheel under mount for steering.

To get that pressure to release, you can wrap a rag around the end, and jam it into the concrete quickly, assuming you can reach the concrete. With the rag over it, it won't damage anything, it's extremely quick, but be cautious of the fluid that will spray (the 2nd use of the rag). Be careful about pushing on those connectors as you described - fluid out = air in, which isn't good. Also - when I park my loader, I run all the hydraulic actuators all the way in. It'll take up less space AND protects your actuators from dust, dirt, debris, or potential damage while stored. Thanks for the video, happy tractoring!

Were can I get that exhaust shield?