Kwikset Smartkey Gen 3 - Picking - Overview of construction and use of tension tools.

No video

Kwikset Smartkey Gen 3 - Picking - Overview of construction and use of tension tools.

Рет қаралды 8,201

Күн бұрын

Picking the Smartkey Gen 3 requires the use of specialised tension tools. This video goes over the construction and use of a pair of tension picks that simplify applying the necessary tension to the pins in order to pick the lock. Link to picking and gutting a Smartkey Gen 3 lock using these tools • KwikSet Smartkey Gen 3...

Пікірлер: 15

@Tipa-fw2rz 24 күн бұрын

I'll be happy to back here for my once again looking 😊

@timmypo 11 ай бұрын

Thanks for the video, I’ve been trying at my own door for hours. My picking skills aren’t that great but I’ll have to buy a shim like your thin one for next time.

@jamesozment1 5 ай бұрын

When i open mine i shall give you credit .

@MattMaxwell 2 жыл бұрын

Have you tried going over the top of the retainer and hitting the sidebar at the exposed point in the middle? It seems like it should be easier.

@roo1yak 2 жыл бұрын

Never tried that approach, heard it mentioned before but never seen a successful pick tensioning that way. I do find that you can bind pins progressively from the front by slowly inserting the tension pick further into the sidebar channel which is advantageous.

@MattMaxwell 2 жыл бұрын

@@roo1yak if you watch the LPL video of the gen3 then he uses a shim over the top.

@roo1yak 2 жыл бұрын

Just watched it, shows there are many ways to attack this lock. A conversation I recently had with another picker suggested you can use the 'rekeying' inlet as well. Cheers for the comment.

@camronbay1 Жыл бұрын

On the knob sets I use a small punch and punch a hole in the back of the plug and use a Allen wrench to turn the spindle to open the knob. The newest deadbolts have a block in the tail piece to prevent the punch method from working.

@ChristiannTyler 8 ай бұрын

Very interesting, Did you make those tools? Been looking online trying to find some if not where did you get the material to make them?

@roo1yak 8 ай бұрын

Yes, I made them. Main tool is made of spring steel with a 3d printed handle, has become a bit more malleable with repeated bending and shaping. Thin tool is from a softdrink can.

@thomasharlos6872 25 күн бұрын

Go to any auto store and buy a set of feeler gauges . then you will have any size from.001 " to .030 " and you gan make the size you want.