Hello Everyone!!! This video explains about what is lap length, development length with examples and guidelines to calculate lap length and development length as per IS-456:2000. Keep watching!!!Enjoy Learning!!!
Пікірлер: 21
@sasikumartherayil96203 жыл бұрын
Madam Try to explain sloping slabs and their detailing forces on wall etc
@_NigmalRajas3 жыл бұрын
Mam Bottom rod is not necessity for development length, in site we are provided only top bar.... It's crt Or wrong
@Pradeep-vl5yf3 жыл бұрын
If slab ratio ly by lx is less than two but not supported on four sides, then it will be designed as two way or one way slab
@CivilEngineeringMastery3 жыл бұрын
Two way slab. please refer the below link kzfaq.info/get/bejne/eZ-Xraik25rcgmw.html kzfaq.info/get/bejne/i8-kecuU0r22kZs.html
@Pradeep-vl5yf3 жыл бұрын
@@CivilEngineeringMastery I've seen that mam, but the above question answer
@CivilEngineeringMastery3 жыл бұрын
ok .If the slab is not supported on four sides it comes under the category of four edges discontinuous. If ly/lx less than 2 then it is two way slab.
@Pradeep-vl5yf3 жыл бұрын
@@CivilEngineeringMastery thank you
@sasikumartherayil96203 жыл бұрын
For two fkur supports are compulsory
@jawaharbharani18663 жыл бұрын
How to design for concealed beam in stadd pro.
@CivilEngineeringMastery3 жыл бұрын
Concealed beam concept is not advisable to use and also which is not mentioned in any of the codes.
@akashbabaria14443 жыл бұрын
Wht is anchorage length mam
@akashbabaria14443 жыл бұрын
Why lap length is considered by small dia
@CYBERxSigma6 ай бұрын
sigma s is 0.87xfy please correct this
@famcivilengineer343 жыл бұрын
You are wrong about lap length Location.. Lap length should not be provided in the middle or end of the member.. Lap length should be provided at L/4 distance from end.. Ome thing more you need to elaborate this topic... Lap length for different members of rcc structure are different like for for column, beam and slab value of lap length differ.. One more question what is minimum value of dev length should be provided..
@CivilEngineeringMastery3 жыл бұрын
Thanks for the notification. Minimum development length should be 300mm.
@sasikumartherayil96203 жыл бұрын
Madam think of Ld, Ld/3 Lap for tension lap for compression. In practice lapping is done wherever they like irrespective of theory.