Thank you for the feedback, those are some good point. I have tried lowering the trailer more in the water, the issue is the current is way to strong and the boat drifts away. What I found works the best specially when I’m by my self is to park the Jeep next to the ramp close as possible and use two lines (front and bank) and walk the boat into the trailer. Then use the trailer ratchet to pull in the rest.

To add to that per yamaha this guy pretty much launched and loaded by the book. The trailer winch is not designed to winch the boat onto the trailer, it’s meant to be power loaded. I can attest to the currents as well. I’m on the gulf and some ramps have way more current from the tidal changes than others. If you are just a hair to deep you will be jackknifed in no time. Happens all the time and it’s a huge mess just watching people trying to get the trailer out of that situation when it’s smashed up against the dock and the current just fights you every step.

I agree. Need to have full control over the boat, our currents can get super bad specially towards the end of the day. And next thing you know your boat is smashing into the dock or worse case into someone’s 300k boat 😂

@@jakefromstatefarm9721 Per Yamaha? Are you talking about a Yamaha dealership told you this?

@@socalifone3044 per my Yamaha owners manual, page 108. Lol.

Thank you, yes I would say everything you mentioned is about the same here in northwest Washington during busy season. If you notice I’m the only boat on the ramp and in the water. During busy times specially on the weekends the ramp is completely full and it’s a different story. I did find a better way to launch the boat by myself, will make a video soon. Basically placing the trailer with the boat close as possible to the ramp, and using front and back boat lines to pull the boat off and on the trailer, then securing the boat to the ramp, then I park. The only issue with that method is the availability on the side ramp, basically when standing in vehicle line to launch the boat you have to make sure to get the spot with the ramp, and there is 4 stops. Two middle spots are wide open just like you see in this video.

@@SurgeWorld Great job teaching this stuff as our boat ramps are disaster areas, people are either clueless or very rude.

@@dcc2444 yea tell me about it. Most people don’t know any better, seen some crazy stuff myself. Like someone was buckling in kids into car seats while seating on the ramp and holding up traffic.

@@SurgeWorld Wow, that's a new one!?! LMAO...

Lol dos and dont in florida ???florida has the most stupid boaters in america lmao

Thank you. It’s a great family boat, never had any issues.

Congratulations! You welcome.

Thank you

Lol thank you! The key is to go out and practice for a bit. I was a bit intimidated my first time at first. Remember when loading the boat back on the trailer get those boat-rails completely wet and have them stick out about a foot!

Glad you enjoyed it

Thank you

The texture is a major plus!

Exactly! Was early morning on the weekdays.

Thank you

Thank you 😊

Thanks! 😃

Thank you

Thank you :)

@@outlaw8388 yes, I believe it’s only 3,000lbs

While on the parking lot, turn on the battery, turn on the blower to check that it runs, get everything setup, life jackets, store away stuff, and always double check the drain plugs. While backing up the boat, turn on the blower, i believe blower has to be on and running for like it least 30 seconds before boat can start. Main thing is always double check the drain plugs!! The person who drives the vehicle will undo the trailer/boat tow ranch, once that’s lose before the security rope/strap gets lose the boat driver will start the boat. Don’t want to cut the boat loose and not be able to start the boat. Once the boat fires up, then the final security strap gets loose and the boat can back up while the driver parks the vehicle. I found much easier to launch the boat using front and back ropes when I’m next to the ramps side walk, then I walk the boat as far as possible, secure the boat. Part the Jeep, get back to the boat, start the blower, undo the ropes and drive off. Reason I like this method much better is because I’m not in a hurry, I can take time and I don’t have to stress with someone helping me ether with backing up or the boat, unless I’m with someone who knows how to backup. Last thing I want is to be stressed out and in a hurry.

I had 3” lift made by zone with 2.0 fox dual reservoir shocks and fox 2.0 steering stabilizer on nato 35s, had ZERO sag!! Extremely comfortable soft ride. Now I have 2022 rubicon 392 with a recon package and it sags a little when I pull the same exact boat, the boat weighs around 3500 pounds. I think upgrading the shocks makes a huge difference! I will be upgrading my soon, maybe to fox 3.0 but man!!! They are expensive. Fox 2.0 is very reasonably priced now.

No. I have 3” TeraFlex lift with FOX 2.0 shocks. On 35” x 12.5” tires and 20” Moto rims.

Breaking is really good, I haven’t noticed any difference at all. The trailer has its own breaks, called a (hydraulic surge breaks) they activate automatically whenever the driver slows the tow vehicle. Boat trailers with surge brakes can often be submerged in water when boats are being retrieved and launched, causing premature corrosion on the components of electric brakes. Surge brakes require no setup or knowledge of the braking system to operate, no electric controller or special wiring, and can be submerged in water.

🍻

Thank you. No it’s FlowMaster outlaw. Here’s my review video; kzfaq.info/get/bejne/qsl9jaqCvrezl2w.html

@@SurgeWorld Hey thank you for the reply, I will check out your video.

What kind of rig do you have?

@@SurgeWorld 2021 F350 Diesel

Oh ok, for some reason I thought different types of rigs would make the difference. I did notice when the fenders are submerged then loading the boat is much more difficult specially when there is a current, because the boat wants to drift away.

@@SurgeWorld they type of tow vehicle shouldn't make a difference if the trailer is level when on flat ground. My first outing when I attempted to load the boat, the front roller was higher than the navigation light on the boat, and I had to back down significantly to get the boat on the trailer correctly. User error. I have a hitch with adjustable height and it was set for something else. Lowering the hitch corrected the issue.

Oh I see, thanks for the tip.

No, I have pulled that trailer with regular v6 wrangler and v8 6.4L wrangler 392 very comfortably around 70mph. The surge breaks are amazing on the trailer.

I have re geared to 4.56, installed flash cal, cold intake, flow master exhaust pipe and fox 2.0 dual shocks. That’s about it. The flash cal has 3 modes, eco, sport and tow. I always have it in sport mode and never had any issues. I think shocks is a big deal, the jeep is super stable.

Forgot to mention one more thing, the Yamaha trailers have 6 pin plugs and I believe your Jeep has 4 pin plug. I had to order 6 pin conversion kit on Amazon for like $20 for the trailer to work.

@@SurgeWorld Yah I tow a camper trailer so I've already had mine wired for 6 pin. I'll probably get mine regeared because I want to run 37's and not lose the get-up and go.

@@travist5674 I would definitely re gear it then. I ran 35s on my rubicon.

No issues at all! Tows perfectly around 65-70pmh and I’m on 35” with 3” lift. I did re-gear to 4.56. Low speed it pulls like nothing! Very impressed.

buy hybride jeep

Hybrid doesn’t help at high speeds

Wrangler pulls this boat with zero issues! I’m on 35s, fox 2.0 shocks, cold air intake, flow master outlaw exhaust and a chip. Stock wrangler Jeeps rated around 3,500lb towing.

@@SurgeWorld That’s good to know. I was looking at this same boat and I also have a 2017 JKU on 37’s and beadlocks with a 3.5” lift. My problem is over hearing while going up hills or trying to drive over 75 on the highway. Especially after I regeared to 5.13’s.

I would say 3 to 5mpr. Key is to keep steady speed all the way otherwise the boat will start drifting with water current and you'll be all over the place. Have the boat ramps stick out about 12" and you'll be fine even if going to fast. Practice the more you practice the better you'll get.

No experience yes! Absolutely, this was my first boat on Columbia river with no boat experience. At first couple of weeks it was a learning curve for sure, once I figured out few tricks like what kind of anchor to use and how to tie ropes this boat turned out to be amazing. Definitely for the money, I would say this boat is bullet proof. Yamaha definitely put allot of energy and engineering behind this model. Now on the gas, I would say it’s okay from the sounds of it compared to prop motors. Overall extremely happy with the boat. Never had any issues. I would recommend getting supercharged like my, top speed is 55 to 60 mph.

Thanks a lot for the info, just subscribed to your channel 😊

I did purchase one during the boat purchase. Boat cover is well build high quality and I think is priced right. I did use the cover few times sense I purchased the boat, otherwise the boat is stored in garage without the cover.

LOL practice makes perfect. I think the hardest part for me was to set the trailer right before loading the boat, main thing is to have boat ramps on the trailer stick out pass the water about 12"

I used to, tell I figured the ramp. I would use 4WD if I was at a new ramp with smooth surface concrete. Otherwise 2WD works great.

@@SurgeWorld getting a 18ft majek. I have a 4 door Jeep high tide so just making sure I can pull and launch it safely with it !

I see, yea try it with 4WD at first to be safe.

Interesting

@@SurgeWorld LOL!

👍🏼

wróñg thats bíg bóàt

It is bit noisy I agree, I actually sold my few weeks ago as well. Will upgrade to FourWins H1 or sea ray. Leaning more towards FourWins H1. Are you getting something else?

@@SurgeWorld its a toss up between a cobia or a mako center console. I really do like the fact yamaha gives u alot of boat for the money I just can't pass how noisy they are

Yea the noise is bit to much. I did like the fact you can beach it anywhere.

@@SurgeWorld why did you sell it?

I want to upgrade to FourWins H1 or sea ray.

Is it using front and rear lines to pull the boat in and out? That would be an easier way as well, will make a video soon.

búy hovrr çraft

Agree

These days I manually pull the boat on and off the trailer. It’s a bit slower, but it works way better.

💯

Agreed