light at the end of the tunnel maybe
Рет қаралды 516
3 ай бұрынthis video we " straighten " the bed and get the last few item check off so we can start testing the printer
#3dprinting
#voron
#klipper
#makerbase
@DarkMatterLP1 3 ай бұрын
what software is that and how is it set up? ive seen the #kipper but ive only seen it run on the printer itself, and yours sais raspi
@loosenutprinting 3 ай бұрын
i see you found my kipper install video hope that has helped answer you questions on how everything your in ran and stuff
@dev-debug 3 ай бұрын
Klipper basically has 2 components. Firmware on the printer board and the Kliippy service you run an something like a Pi. Klipper don't provide a user interface though. The interface he is using is called Mainsail. If you're talking about the top left corner it's what the printer name is set to in Mainsail options.
@ShrirajGPethe 3 ай бұрын
I suppose first comment and first like
@loosenutprinting 3 ай бұрын
you get a internet cookie lol. thanks for the comment
SmarterEveryDay
Рет қаралды 460 М.
loose nut printing
Рет қаралды 1,3 М.
Immersed
Рет қаралды 6 МЛН
ГЛАЗУРЬ СТЕКЛО для iPhone и аксессуары OTU
Рет қаралды 6 МЛН