Thanks. Using a blueprint for the cube is a very good idea.

Will, you must have read my mind. I just bought one, so this video is so timely. Thanks again for your efforts.

Hi Will, thank you for all the good videos. I really like your beginners guide. Can you do an intermediate guide as well? You already covered a number of topics in the past. It would be nice to have a playlist which build towards the next level of using homs assistant.

Hi Will, once again thank you for another great video. may I ask this question, I have a Sonoff RF bridge ( flashed Tasmota ) and it works fine with all my 433mhz sensors, however, i bought a new 433mhz door sensor and I dont see the code coming up in the console of tasmota ? Any idea why the RF bridge is not seeing the Door sensor. ( They close together ) Thanks

I use the vibration sensor for my dryer. When it stops vibrating for 2 minutes it sends me a notification that the dryer is done. My problem is that every time HA boots up it sends the same notification. Any idea on how to prevent that? Maybe something to do with the tilt sensor that is also part of the vibration sensor. I also have a cube and will be setting it up with the blueprint as well...thanks for that!

cool project... what module/device you use to receive ZigBee information into home assistant?

Why on earth would you spend so much time on unpackaging these sensors, I came here for information, not to look how you fumble with carton packages, what a waste of time!!!!!