thanks! the main issue was getting the turrets to index reliably as they were rusted badly inside... :( otherwise it was pretty straightforward. this config is severely limited without 2 independent g-code channels which is hard to do with the linuxcnc currently. i hope i'll get an opportunity to work on it

yes, TX8i is a mitsubishi meldas 500. using my own interface cards - two YMDS2P (yurtaev.com). yes the drives are original mitsubishi MDS-x-V/SP

@@m3rkwurdigliebe you are perfect👍 How many axes does your interface board support? Which servo motors does it work with? and how much is the price? we have a traub tnk 28

@@israfilcaglar9216 the card has a single channel, so it supports 7 drives - the max the control protocol allows. had to use 2 cards with this traub. i can work with pretty much every mitsubisi motor/drive except mr-j2-*ct. please email me if you are interested...

it's far from finished yet, 2 turrets were just mapped to ZX/WU axes. very limited usability actually. when i have time and a bit of inspiration - i'll clean up and put all my linuxcnc configs on github

the 2nd carriage UW plane is pretty limited: no G2/G3 support, no spindle sync moves and maybe something more. and of course ideallay the controller need 2 separate channels... ask me if you want to know something specific

yurtaev@gmail.com