I'm glad I found this video. Just in time for my install of two 12w7's and two HD750/1's to push them!

Proper amp setup is totally important!! Love teaching customers about this!

This is my favorite video in the JL help section. Helped a lot with my own setups.

It is so easy to set these new amps up! I love it

I definitely learnt a lot from this! I currently have JL audio speakers on my doors and trunk. I am building a full JL audio system. Always loved JL audio since I was a kid growing up! Thanks for sharing!

Great info... look forward to checking out other videos in the series!

Favorite Help Center Video! Yes I watched every bit. Very informative and helpful. I like to know my equipment in depth

Love this video. It speaks to not only JL products. All of our customers can benefit from watching this. Great info broken down and very helpful.

Favorite informational video so far . Haven’t had the pleasure of owning a VXI amp yet .

So far this is my favorite video here. I'm sure I'll find more.

This my favorite video on all of KZfaq!

This was my favorite helped me program my amp. 2020 giveaway and easy for many more. Jp quiso by far my favorite amps to get.

Great resource! Thank you for the time and info.

My favorite video. Great topic and excellent amplifiers.

Great video to help with new build first build in over 15 years

Thanks for the great info definitely will help on future projects !!!

Thank you for always providing great information. 👍🏾

JL Audio is and always will be the king of audio. Audiophile’s rejoice!

With such good info this is my favorite. Great job!

Such an important factor to know especially when building and adding more power and sound.

I shore wish I had watched this before setting up my RD900/5 amplifier. Only running the sub channel at the moment which is why I was scratching my head why I had to run a remote turn on wire when I wanted to use DC Offset but was unable to, now it makes sense, only works on channel 1 which I’m not currently using. Lots of good information!

This is my favorite video here. A lot of great info!

Rob was an angel of patience... Good job buddy.

Best and most helpful video for me personally. JL Audio y’all ROCK! Merry Christmas from Western KY!

love these videos! please keep doing them.

Really enjoy watching these educational videos! Thanks

This is my favorite help center video very descriptive and helpful

Great video found it very helpful thank you ... love JL AUDIO especially my w7

This is my favorite video JL Audio for life

This helped a lot with my 25 year old band pass box from JL

Favorite video of 2020. JL audio is the best.

This is my favorite, since I'm working on my system

This is my top favorite video .. super useful information ..thank you

ive played with stereo stuff for years , and its nice to learn something new

This is my favorite help video and they are all very helpful! I can’t wait to own a VXi Amplifier and upgrade from my Slash. Happy New Years!

Awesome tutorial, JL for the win!

this is my favorite video by far!!

Perfect timing to tune my slash 1000/1!

Great video! Keep up the amazing work.

JL OVER EVERYTHING !!! STEVVVVVVVVEEEEEEE THE GOAT !!!! ONE OF YOUR BIGGEST FAN OF JL AUDIO since 06 WITH THE HELP OF MATT M. !!

Great info! Thank you!

Love these videos, so informative!

This is my Favorite. 2020 Giveaway. JL Audio For Life!

this is what i have been looking for!

Awesome training videos. I didn’t know you guys had these videos until I read about it on the “Prize Giveaway” post on IG . Keep up the good work

The clipping light such a great idea

What an awesome video! I read manuals and tuned my amp for my XD300/12TS3 power wedge to 24.5v as the manual said at 3/4 of the volume . (Thanks for the sound file from your website) It didn’t quite sound/feel loud enough for my normal listening level. I did this before watching this video. Half volume is very loud on the stock Bose system in my truck, so I think I will tune it the same way but at half volume. If I decide to go louder than half, can I just use the remote to lower the sub volume in that scenario even though it would probably be very temporary? This video just made everything so much easier to understand when installing a new sub!

Super helpful video!

this was very helpful

I love how the premium line amps have a clipping light for easy setting

Good stuff, thanks!

Great products!!!

Really good info

Hi, you mentioned something about the TwK88 and input sensitivity. My source unit has a 5v pre-out and distorts at volume 48/50. Am I right in saying that the lower the voltage number on the input side, the less gain I will need to use at the amplifier? I ask because right now, with the volume at where it is, the input is set at 7.1, which yields in me having to turn the gain up high, I normally run direct from source to amp and I don't have to crank up the gain so much, it normally clips at just under 1/4 of a turn.

This was helpful

My favorite

Great vid this is my favorite video

Could ya explain to me why the 13.5W7 surround mold and crack off? And is there a recall for this subwoofer?

I am truly educated here by JLAudio and glad to learn that people behind the products are really smart and informative. I have a question. For analog frequency filters, if I want my midrange to work fully at 300Hz, I have to set filter to high-pass mode and the potentiometer to 300/1.4 Hz or 214 Hz (at -6 dB) and then the power will drop 12 dB from 300 to 150 Hz. I already check out the manual and there is no information about at what frequency the filter starts to cut off for a given potentiometer value?

Thanks you JL for these awesome videos. I just had a new VXi700/5 installed as well as high end speakers and a JL Subwoofer (Professionally installed by retailer), and watching these videos gives me an appreciation of car audio system setup, as well as becoming more familiar with my system.

Merry xmas!!

I have to vouch to the quality of JLAudio, I purchased a HD 900/5 amp and 10w6 sub back in 2007-8, they have seen three car installs along the way, the amp is still running strong and being used in my current system, the sub has finally gave out last month, the cone separated from the foam baffle on the outside, I know I could probably send it back and get it fixed (16+ years of jamming, cant complain!), but I decided to get a new one in your pre-made ported box, may still send back to see if the old one can be fixed. So I have a question about setting gains, I'm currently running Focal elite 165k2 two ways, the crossovers have sperate outputs for both the tweeter and mids, so, I have the tweeters running off the front channel and the mids running off the rear channels, should I use different test tones for each channel now that the mid and tweeter are running off separate channels? and if so, what test tones should I use for them? Also does this make any sense running them like this, is there any sound quality gain having the mid and tweeters getting more "power" or should I just run them off the front channel? thanks

What is “desirable” level of clipping for a sub in terms of a percentage of voltage above spec on a DMM? Sub is JL M7 12” Also, my Fusion RA770 doesn’t clip at full volume on my SMD-1 so I set the gains at full volume

Great Info! Can I use also the DMM method on a JD400/4 as well as the clipping LED?

...setting the output of the twk 88 would be awesome.

Do all jd amps have clip indicator, what would be the reason mine isn't turning on?

Does anyone know the process to set up the amplifier gains going from Head Unit, to Twk, to non JL Audio Amplifier?

Hi @JLaudio Just getting back into putting bass in my car after around 15 years gap so slightly rusty. I haven’t really used JL Audio in the past but after research I am sold. So I’d like around 500rms and am very interested in a single 10w3v-2, space is an issue so will be getting a custom sealed enclosure made specifically for it with all recommendations set by JL. My question is would the JD500/1 amp be a good partner for the sub? Many thanks

Should this process be done with the engine running or engine off? Thank you.

The dealers needs to get trained right because most don't know jack. They just want to sell specially around Los Angeles area. Any recommendations?

someone tried to take my amp out of my trunk and now it wont work and they told me it was the RCA jack. I can not afford to pay 125 dollars to have them fix how can i fix myself

Is there an email I can send my plans to to have JL verify my thought process in building my system?

ME GUSTARIA QUE EN UN FUTURO TAMVIEN EXPLICARAN TODO EN ESPANOL PORQUE MUCHAS PERSONAS COMO YO NO ENTENDEMOS MUCHAS COSAS PORQUE NO ENTENDEMOS MUCHO EL INGLES GRACIAS

Very helpful video, JL Audio or nothing!

Done this hundreds of times setting levels at 3/4. When you set the bass knob all the way up and adjust at 3/4. Everything below that and below half has 0 bass to the sub. Not sure that’s the best setting.

West palm tapping In

I’ve always been happy with JL products, I’ve been using them since 2000. Never a problem but I wouldn’t want to be a manufacturer. I’ve seen teenage idiots ( is there any other kind?) do everything wrong. 10 gauge wire from battery post to frame. Using amp gain AND Bass boost as volume control, 2 4 ohm subs wired series and claiming subs are junk with no output. You name it I’ve seen it.

I wish every manufacturer had videos like JL! Someday I will be able to afford a full JL setup. Their subs and Amps combined give you a setup that will literally blow off your socks!

Boom on

Hey saludos espero que esten bien, nos hemos visto antes, en los show del mea soy de Buff,NY Trabajo para Lou Latif, de AudioOne. Gracias por su valioso tiempo. Aunque a veces sepamos esto muchas veces las pasamos por alto por que nos olvidamos de algunos detalles. Detalles muy importantes que terminan en dolores de cabeza. siempre estoy pendiente de sus videos….es como el sistema de mantenimiento que le doy al conocimiento. Gracias espero que esten bien.

My amp is the Rd 1500

who ever said your product doesnt last is foolish. have the 13w7 built in 2005 and still works. also slash

I have a lot to learn still.....

𝕲𝖗𝖊𝖆𝖙 𝖛𝖎𝖉𝖊𝖔 . 𝕮𝖆𝖗 𝖆𝖚𝖉𝖎𝖔 𝖘𝖔𝖚𝖓𝖉 𝖇𝖗𝖔𝖐𝖊𝖓 𝖉𝖔𝖜𝖓𝖙𝖔𝖆 𝖘𝖈𝖎𝖊𝖓𝖈𝖊. 👍🏽

Steve Turrisi has a slight Christopher Walken accent going on “you’re…setting your…gains all wrong, if you…set it…too high, I’m gonna have to…clip YOU”

Big fail on these amps. No hi level inputs?

Hello how are you? Lets grow togther.. thank you see u aroud too.

That's some serious abuse to tear/rip the spider or surround!

People always cheap out on amplifiers. A great amp is as important as the speakers!

Great video, keep up the great work!