Loading & Unloading a Container Using a Galbreath U5-OR-174 Roll-Off Truck

Loading & Unloading a Container Using a Galbreath U5-OR-174 Roll-Off Truck - Tips & Best Practices

Рет қаралды 57,207

3 жыл бұрын

Bryan Bachmann, Product Manager for Roll-offs & Hooklifts here at Custom Truck One Source, demonstrates how to load and unload a trash container using a Galbreath U5-OR-174 cable hoist roll-off truck. Also see tips on putting the tarp on and off the container to prepare for container transporting.

Пікірлер: 31

@jafarmoghadam7712 Ай бұрын

Excellent ❤❤❤❤

@godngunclinger 2 жыл бұрын

you put some pretty good scratches in the pavement by not letting the winch pull the truck under the container at 1:45

@casperaudi7476 2 жыл бұрын

Thank you 🙏 I was looking for information I got my answers this is what I want to after retirement in 4 years thanks 😊

@markinson561 3 жыл бұрын

Drop the boom about 4 inch from ground (I usually tap ground then come up slightly). Tap box with boom. Place hook on then pull box on or ideally, allow load to pull truck underneath box! Strap then tarp.

@Fine39XMEN 3 жыл бұрын

Markinson, that’s exactly how I do it! All day, every day.

@MrTrent1972 3 жыл бұрын

Umm, no. Look at the damage you just did to the asphalt. Let the cable pull you into the bin. The less the bin moves on the ground the better.

@Fine39XMEN 3 жыл бұрын

Trent - the stopping three feet before the truck hoist/boon taps the can, causes unnecessary damage to the cable when pulling the can up. Never seen it done like that before. Like you said, unnecessary damage can occur doing it that way. We put a lot of containers in driveways and have to do everything we can not to tear up the customers’ driveways when we go to pick up/load the containers.

@customtruckonesource2029 3 жыл бұрын

For the purpose of training and filming, it was easier to apply the parking brake, and move the container.

@KaiserStormTracking 2 жыл бұрын

@@Fine39XMEN which is why its ideal to have something like plywood over the surface where the container is if im correct

@mrad.13 2 жыл бұрын

I was thinking the same thing. Why did he drag the can rather than back to it.

@wastemanagementtruck1015 2 жыл бұрын

Very nice & Smart system. 👍

@Dolomedesspider 2 жыл бұрын

Not even a trucker, but I'm happy that those wire systems are history here. Most units got the hook frame instead. Here is an 'typical' half pipe bunks asphalt hauling unit for city pavement job purpose - bigger roads= more common with trailer units. kzfaq.info/get/bejne/jdx4gsyaqr3ecXk.html

@dannycastro6463 3 жыл бұрын

This was a good video but so far I haven’t seen one where it shows detailed operation of how to use all the controllers on picking up and dropping off

@customtruckonesource2029 3 жыл бұрын

If you have specific questions, or would like to see more detailed training, we can provide that also. A simple explanation is the same levers for the hoist are outside, and inside. Use the winch on lever on the tower, to pull the container on, forward of the rear hinge. At this point, you can start to lower the hoist with the raise/lower lever on the tower. Winch the container on further, make sure the sills are aligned, and then lower the hoist to the truck frame.

@jerryroscoe1791 8 ай бұрын

😅 you just gotta take your time

@jamesnorris907 11 ай бұрын

Ok let me stop you right there ive been operating roll off for 30 yes and my suggestion to protect your box and prevent it from shifting off the rails is before raising my boom i make sure my tail is extended out and then baxk slowly to the wheel rollers of the container then proceed to hook the cable on once in the truck winch up past the first rollers and release the air brakes and as your winching up the weight will pull the truck under the container as you continue to adjust your angle and keeping the nose as low as possible once 80 percent of it is on and there isnt any weight on the tail then proceed to lower your boom and and a safe point winch it in tight and lower the little remaining amount .... ive seen to many guys tip sideways cause they werent controlling the truck as it goes under the box 👌👌👌

@kaylebarker4081 2 жыл бұрын

Clearly more of a product video as opposed to a training video. Which is just fine, but it might be a good idea to be clear on what the video is for. Great looking product btw.

@Joseph-pc2ys 2 жыл бұрын

I have a hoist that's 8 inches by 4 and half inches thick and I want make an extension tail if I buy a frame 7 by 3 will it fit in there . Please let me know or are you selling the tail already.