Pin gauge set is a must if building, one must check the gas port hole of new barrels. Before the build even starts.

Nice presentation man!

Excellent Pete. That 16" rifle length gas I had was manufactured at .098 and a lot of guys were saying they had to go 1.09 to get theirs running. I didn't like that the feed ramps/extension were not a smooth even transition. I'll never know what the real issue was, but your diagnosis videos are great.

Somewhere in the desert outside North Las Vegas are Pete and his rifle as we speak!

Nice how they got the port within a groove

Looking forward to the range time

Very thorough.

And people pay for cable TV or streaming services… I have Peter Egger TV. 😂. Your videos are always interesting and well produced.

Also look into a fiber light, that can be used down the gas tube, one can use that as a back lighting aspect when using the bore camera.

Brake cleaner down the gas tube is a great way to flush any suspected debris out without taking it down.

check the BCG, for wear on locking lugs on bolt. See if its an issue unlocking.

I’m Praying She’s Fixed 😀😊😇😇😇 Pete

To eliminate the gas problem put a non adjustable gas block on and see how it works that gas block you have looks very fancy and from my experience fancy doesn't always equal function.

Cool man.

This is one of the MANY reasons I don’t use adjustable GB’s. In my over gassed cans I’ll use the Bootleg adjustable BCG. Again only with a over gassed suppressor. You can look into BRT gas tubes as well if it’s truly over gassed, that may fix your problem.

Other than that tall bolt catch and the abnormal wear on the Odin works BCG everything looks perfect. I suspect that Odin BCG or possibly the barrel extension. But only if the Wilson Combat BCGs are not wearing or having any function problems. Do they run and function ok? Do you have a good ex military or very highly experienced gunsmiths around? It may be worth just talking to one, and showing him the Odin works BCG. (if not taking the rifle in to inspect.) Here is a tip I use often. A set of 0-60 and 61 -80 Numbered drill bits makes a pretty economical and much more usable basic set of gauge pins for small things like gas ports, etc. (if buying a set of small gauge pins is too costly and not really needed ,other than this very rare instance) I use them to check very small holes for diameter all the time, and I also have a set of gauge pins for larger holes. Sort them with a caliper when they get mixed up, in order to put them back into the index. Hope that helps.

Good luck with GB. Please let us know if you get it to work. I’m having similar problems with my 7.62