Пистолет - карабин... Люгер.

Why not use a dermal with a thin grinder ?

As a German, I always have mixed emotions when I think of the guns that were brought to America after the end of WWII. But to be honest.., I rather see them being taken care of and appreciated in America than neglected or destroyed by the government in Germany.

Outstanding!

Standard length of pull @ 13 3/8”.

I like to think that I am fairly good shade tree gunsmith. But I thoroughly enjoy watching and completely appreciate absorbing and gleaning any information knowledge and skills that I can pick up from you Mr. Novak! Thank you so much for your service and putting all this information out there for people like us that love firearms so completely thank you again!

Funny enough i have done about the exact same thing assembling plastic miniatures the only differences being A. its in plastic, B. i use exact knives (razorblades).

U started with a piece of wood just to small .... hehe...

Hello, Sir and 1000 Thanks for this video. How I wish I could have that tool for checkering, and how I wish I could hand make grips for some pistols. But about Lugers everything for them is always very complicated!! Grip pannels are no exeption here. It is always such a pleasure to watch you working.

素晴らしい作品

All Michelangelo had to do was remove the unnecessary stone to reveal the David statue (and not a whisker more). Simple really.

17 inches of pull

I nearly passed out twice from holding my breath while watching this delicate work.

dream gun for me

I’ve been watching it for a long time now, and I never seen you use a welder on a barrel gun you need to check out R&R restores of guns because they’re made welding all the pits all over the barrel

мужик серезный , золотые руки , молодец

It is pleasure like always

Bnyk omong..

Congratulations Brasil, VERY VERY VERY NICE WORK, I LIKE IT

With all due respect Mark, if that chisel slips one way or another…. you will heal, but the Luger won’t.